Shockwave S6 User Manual
  1. Manuals
  2. Brands
  3. Shockwave Manuals
  4. Marine Equipment
  5. S6
  6. User manual

Shockwave S6 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
USER MANUAL
MARINE
SUSPENSION
MODULE

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S6 and is the answer not in the manual?

Questions and answers

Related Manuals for Shockwave S6

Summary of Contents for Shockwave S6

  • Page 1 USER MANUAL MARINE SUSPENSION MODULE...
  • Page 2 SETTING UP THE SUSPENSION MODULE • Commander Heated Seat STEPS TO SET UP THE SUSPENSION MODULE Serial Number: • SHOCKWAVE S6 Swivel Slide, Swivel, and Slide. CHANGING SUSPENSION MODULE HEIGHT (sold separately or as an assembled option) SERVICE TIPS SUSPENSION MODULE DRAWING (SW-07366)

  • Page 3: Important Instructions

    The footrest surface should be 0” to 5” [0mm to 150mm] below the base of the S6, 7” to 16” [175mm to 405mm] in front of the S6, and at least 16” [405mm] wide.

  • Page 4: Getting Started

    BEFORE YOU START GETTING STARTED The maximum occupant weight for the S6 module is 300lbs [135kg] Congratulations on your purchase of a SHOCKWAVE S6 Marine Suspension Module. on a vessel that sees maximum deck accelerations of 5g’s. When We hope you enjoy this new boating experience offering you access to new possibilities on the water.

  • Page 5: Setting Up The Suspension Module

    Strength of decks and deck mountings is the responsibility of the boat builder or Do not sit on the seat with the SHOCKWAVE S6 Pump attached! Damage will installer of the seats. SHOCKWAVE assumes no liability for suspension modules occur to the shock and pump.

  • Page 6: Changing Suspension Module Height

    Ratchet LEAKS: The shock absorber may need to be topped up SHOCKWAVE recommends that all bolts should be visibly occasionally. While it is recommended to regularly check inspected for signs of being loose after every 125 hours of sag and shock settings, the shock absorber does not use.

  • Page 7: Replacement Parts

    REPLACEMENT PARTS EMERGENCY PROCEDURES/TROUBLESHOOTING While your SHOCKWAVE S6 Marine Suspension Module is designed to last, you may want to refresh some of the higher wear components to keep it in peak operating condition. CONDITION CAUSE SOLUTION(S) If the component you require isn’t shown here, please contact support@shockwaveseats.com...
  • Page 8 6” of travel and is foot operated for to either side of the armrest. Available designed to pair with the S6 and the The Commander Seat is designed to add an extra element of comfort and support ease of use. It offers a stable 17” wide in black, this cupholder will hold your Commander Seat.

  • Page 9: Caution Notes

    Your SHOCKWAVE S6 Marine Suspension Module will mitigate the effects of shock and vibration, reducing the potential of injury, but it will NOT prevent the possibility of injury. The increased level of comfort and control provided by your SHOCKWAVE S6 Marine Suspension Seating will allow the craft to operate at higher speeds in sea states which create operation in rough seas.

  • Page 10: Warranty And Warranty Policy

    90 days or 750 hours of use, whichever comes first, excluding normal wear and tear. Rips, tears, abrasions and installation damages are not covered by warranty. S6 finish is not covered by warranty if corrosion is a result of abuse or lack of maintenance. Modules must be @SHOCKWAVESEATS cleaned with fresh water after every use.
  • Page 11 SW-08331 REV00...

Table of Contents