Mouse Control - Lorex L15LD400 Series Quick Start Manual

STEP 1 - SET uP YOuR MONiTOR FiRST
1
2
3
4
5
L15LD420/L17LD420 Series Quick Set-up Guide R1
CONNECT CaMERaS TO THE MONiTOR:
connect the first camera to the cH1 input. follow the same steps to connect the
additional cameras.
1. Connect the Female BNC end of the supplied 60' extension cable to the camera.
Connect the male Power end of the extension cable to the camera.
2. Connect the Female end of the supplied 60' extension cable to an open BNC
camera input on the back of the System. Connect the female Power end of the
extension cable to one of end of the 4 in one power adaptor.
CONNECT THE ETHERNET CaBLE:
connect one end of the ethernet cable to one of the router's (not included) Lan
ports and the other end to monitor's network port located at the bottom of the
monitor. see picture below showing a generic Lan/wan connection.
LAN (LOCAL AREA NETWORK)
BACK OF THE ROUTER SHOWN
TO YOUR COMPUTER
CONNECT THE MOuSE:
connect the mouse to the ps2 port of the monitor.


MOuSE CONTROL

aVaiLaBLE
CONNECT POWER CaBLE:
connect one end of the power adaptor to the monitor, the other end to an electrical
outlet. this unit powers on once it is plugged in to the power outlet.
SET THE TiME aND DaTE:
1. press the menu button from the front panel of the monitor (or remote control), or use the
mouse and click the menu icon
2. dvr Log in screen appears soon after the menu button is pressed asking for a password.
note: user id by default is admin. password is numeric and is not needed for initial menu
setup. press enter to enter the main menu.
3. on the main menu screen select configuration and select time & date.
4. change or alter the factory default settings and press esc to exit this menu.
Congratulations! You have completed Step 1 successfully. You can now view,
record and playback images on your monitor.
IMPORTANT NOTE: The ends of the extension cable are NOT
the same - one end has a Male power port, and the other has
a Female power port. Before permanently running the Camera
Extension Cable, make sure that the cable has been oriented
between the Camera and the unit correctly
WAN (WIDE
AREA NETWORK)
TO YOUR MONITOR
.

After you see
camera images
on your monitor
screen, remove
the protective film
from camera(s)
and monitor
screen.
Make sure that
the Date and time
are set prior to
recording.