Steren BIKE-300 - 4 in 1 Bike Light Manual

IMPORTANT

Read these manual to avoid any damage.
The instructions of these manual are for reference about the product.
There may be differences due to update.
Please check our web site www.steren.com to obtain the latest version of the instruction manual.

• Do not leave the lantern unattended while it is connected to the power source.
• Do not use the lantern if it has been dropped or damaged in any way.
• Repairs should be performed by qualified personnel.
• Do not exceed 8 m distance between the speaker and the Bluetooth device.
• This device is not intended for use by people (including children), whose physical, sensory or mental abilities are different or reduced, or lack experience or knowledge.
• Children should be supervised to ensure they do not use the device as a toy.
• Before first use, charge the battery to 100%.
• Place the lantern on a flat surface, free from vibration and away from heat sources.
• For safety, you must drive with caution and pay full attention to the surroundings during the bicycle ride. Avoid getting distracted by the lantern.
• Do not immerse in water or any other liquid.

The operation of this device is subject to the following two conditions:

1. it is possible that this device may not cause harmful interference and
2. this device must accept any interference, including interference that may cause undesired operation.

CONTENT

PARTS

INSTALL IN BIKE

1. Loosen the holder screw and remove it. Then insert the rubber into the holder.
   
   
2. Place the holder on the bike handlebar. Insert and tighten the screw until the holder is fixed.
   
   
3. Loosen the lock holder and insert the lantern clip. Once you have inserted it, tighten the lock holder.
   
   
4. Place the lantern in the clip holder by twisting it until it is fixed. Adjust the lock holder.
   

CHARGING BATTERY

Fully charge the battery for 4 hours before using it. During charging the LED indicator will flashing in red color

USING LANTERN

To turn on or off the lantern press and hold the button

Press the button each time that you want to change the type of lighting.
The sequence is the following:

• High intensity
• Low intensity
• Flash (medium speed)
• Flash (slow speed)
• Flash (fast speed)

CHARGING A MOBILE DEVICE

Make sure that the lantern has enough charge to be able to use it as backup battery.

Use the device as backup battery. Connect the mobile device as shown in the image:

Disconnect the cable once the mobile device has finished charging. Charging times will depend on your Smartphone characteristics.

USING THE SPEAKER

TURN ON / TURN OFF

To turn on the speaker, press the button
To turn it off, press it again.

BLUETOOTH MODE

1. Turn on the speaker.
2. If it is necessary, press the button to change to Bluetooth mode. The LED indicator will flash in blue color
3. On your Bluetooth device, search and select Steren BIKE-300. If it is necessary, enter password 0000. If the pairing is successful, you will hear a tone.
4. Start playing audio from your mobile device.

MICRO SD MODE

1. Turn on the speaker.
2. Insert a Micro SD (with MP3 files) into the corresponding slot.
   Playback will start automatically.

AUXILIARY

1. Turn on the speaker.
2. Insert a 3.5 mm auxiliary cable (not included) in the speaker auxiliary input and into the playback music device.

FM RADIO MODE

1. Connect the USB - micro USB cable into the USB port to use it as an antenna.
2. Turn on the speaker.
3. Press the button to change to Radio FM mode.
4. Press and hold for a few seconds the button for search and save in memory the radio stations.
5. Once the search is complete, use the speaker as follows:

PLAYBACK MUSIC

*Only for Bluetooth and Micro SD mode

HANDS FREE

HANDS FREE*

The smartphone and the speaker must be paired via bluetooth

SPECIFICATIONS

Input: 5 V 1 A
Output: 5 V 1 A max.
Power output: 3 Wrms
Frequency response: 30 Hz-20 kHz
Sensitivity: 80 dB +/- 3 dB
Bluetooth version: 4.0
Internal battery: 3.7 V - - - 4 000 mAh

Product: 4 in 1 bike light
Part number: BIKE-300
Brand: Steren

WARRANTY

This Steren product is warranted under normal usage against defects in workmanship and materials to the original purchaser for one year and three months on the battery from the date of purchase.

CONDITIONS

1. This warranty card with all the required information, invoice, product box or package, and product, must be presented when warranty service is required.
2. If the product is in the warranty time, the company will repair it free of charge.
3. The repairing time will not exceed 30 natural days, from the day the claim was received.
4. Steren sell parts, components, consumables and accessories to customer, as well as warranty service, at any of the addresses mentioned later.

THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky batteries, failure to follow enclosed instructions, improper repair by unauthorized personnel, improper safe keeping, among others.

1. The consumer can also claim the warranty service in the purchase establishment.
2. If you lose the warranty card, we can reissue it, if you show the invoice or purchase ticket.

RETAILER INFORMATION
Name of the retailer
Address
Product

Customer Service Center
01 800 500 9000