Table of Contents
Advertisement
Setting up
Connections
R If you do not connect the telephone line
cord and use only cellular lines, set the
cellular line only mode to use this unit more
conveniently (page 18).
n Base unit
Run the telephone line cord (
2
adaptor (
) through the slot of the stand.
Connect the telephone line cord (
2
AC adaptor (
) to the jacks at the
bottom of the unit until you hear a click.
Connect the AC adaptor to the power
outlet.
Connect the telephone line cord to the
single-line telephone jack (RJ11C) until
you hear a click.
A DSL/ADSL filter (not supplied) is
required if you have DSL/ADSL service.
Note:
R Use only the supplied Panasonic AC
adaptor PNLV238.
1
1
2
1
PRL262C_PRD262C_OI_(en_en)_0113_ver030.pdf
n Charger
Note:
R Use only the supplied Panasonic AC
1
) and AC
1
) and
Battery installation
R USE ONLY rechargeable Ni-MH batteries
R Do NOT use Alkaline/Manganese/Ni-Cd
R Confirm correct polarities (
4
5
3
2
R Follow the directions on the display to set
Battery charging
2
Charge for about 7 hours.
R Confirm "Charging" is displayed (
9
Getting Started
Connect the AC adaptor plug to the
charger until you hear a click.
Connect the AC adaptor to the power
outlet.
adaptor PNLV233.
1
1
AAA (R03) size (
).
batteries.
1
up the unit.
2
,
).
1
).
9
2014/01/13
16:00:07
Advertisement
Table of Contents
