Fujitsu General ASHG07KPCE Service Manual page 127

1. Function settings
To adjust the functions of this product according to the installation environment, various types of
function settings are available.
NOTE: Incorrect settings can cause a product malfunction.
1-1. Function settings by using remote controller
Some function settings can be changed on the remote controller. After confirming the setting proce-
dure and the content of each function setting, select appropriate functions for your installation envi-
ronment.
¢ Setting procedure by using wireless remote controller
The function number and the associated setting value are displayed on the LCD of the remote con-
troller. Follow the instructions written in the local setup procedure supplied with the remote controller,
and select appropriate setting according to the installation environment.
Before connecting the power supply of the indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake.
Then, connect the power supply of the indoor unit.
Entering function setting mode:
While pressing the FAN SPEED button and TEMP./SELECT (
RESET button to enter the function setting mode.
STEP 1: Setting the remote controller custom code
Use the following steps to select the custom code of the remote controller. (The signal is correctly
sent and received only when the custom codes of the air conditioner and the remote controller
match.)
The custom codes that are set through this process are applicable only to the signal in the function
setting.
For details on how to set the custom codes through the normal process, refer to
ting for wireless remote controller"
1. Press the TEMP./SELECT (
code between
air conditioner custom code. (Initially set to .) If the custom code
does not need to be selected, press the MODE button, and proceed
to STEP 2.
2. Press the MODE button to accept the custom code, and proceed to
STEP 2.
NOTES:
• The air conditioner custom code is set to
• The remote controller resets to custom code
replaced. If you use a custom code other than code , reset the custom code after replacing the
batteries.
• If you do not know the air conditioner custom code setting, try each of the custom codes ( →
→ → ) until you find the code that operates the air conditioner.
1-1. Function settings by using remote controller
on page 05-6.
) ( ) buttons to change the custom
→ → → . Match the code on the display to the
prior to shipment.
- (05-1) -
) button simultaneously, press the
when the batteries on the remote controller are
"Custom code set-
1. Function settings