Table of Contents
Advertisement
Shanghai Baudcom Communication Device Co.,Ltd
2.1 Standard package contents
When you receive our products, please check carefully to make sure there are no defects in our
products. If there is a problem with the transportation, please contact the transportation company;
For other damage or missing parts, please contact the distributor.
4GE+POE XPON SFU ONU
2.2 Fast installation
1. Connect the optical cable to the local machine。
a) Remove the protective cover of the optical fiber。
b) Clean the end of the optical fiber with an optical fiber end cleaner。
Remove the protective cover of the SFU optical interface (PON interface). Connect the
optical fiber to the PON port on the device.
Note: When measuring the optical power before connecting to the SFU, it is recommended to
use the PON online power meter。
When connecting, pay attention：
Keep fiber connectors and fibers clean。
ensure that the optical fiber is not bent, l and that the bent diameter is greater than 6cm.
Otherwise, the optical signal loss may increase to the point where the signal becomes
unusable。
protective caps to protect against dust and moisture。
2. Power on the device. Press the power button。
3. After the SFU is powered on, the indicator should run as usual. Check whether the PON port
status indicator is steady on. If yes, the connection is normal. Otherwise, the fault is caused
by the physical connection or the optical power level at both ends. This can be caused by too
much or too little attenuation on the fiber. Refer to the "Layout Instructions" section of this
installation manual for normal LED behavior. .
Website: http://www.baudcom.com.cn
Chapter 2 Quick Installation
Contents
Power adapter
The user manual
Email: info@baudcom.com.cn
Description
5
1
1
1
Tel: +86 21 37709251
Advertisement
Table of Contents
