Output Image; Special Instruction - Opticon MDI-4 00/N210 Series Instruction Manual

3.3.3.

Output Image

The Image Information format is used for the image output. The way to output an image varies
depending on the transmission modes. The output images in each transmission mode are as shown
below.
1. PART transmission
The image information (information) is sent in the first packet, followed by the image itself (Data).
Packet 0
Start Char rec No = 0
Packet 1
Start Char rec No = 1
.
.
.
Packet n
Start Char rec No = n
2. ALL transmission
The image information (information) and the image itself (Data) are all send in the first packet.
Packet 0
Start Char rec No = 0

3.4. Special Instruction

・ Bar codes and 2D codes cannot be read during image capture mode.
・ An image which was used for reading a bar code or 2D code is not output.
Length = 256 Information
Length Data
Length Data
Length Information
12
MDI-4x00 / N210 Image Capture
Image Capture Manual
Check Sum
Check Sum
Check Sum
Data Check Sum
End Char
End Char
End Char
End Char