Hatco GRBW Series Installation And Operating Manual page 12

Front Enclosure and Side Panels
One plastic front enclosure and two plastic side panels are
available as an option for all GRBW models. Use the following
procedure to install the front enclosure and side panels.
1. Attach the two enclosure brackets and the two panel
brackets to the bottom of the unit.
a. Unscrew the four feet or legs from each corner of the
unit.
b. Screw the feet or legs through the appropriate brackets
and into the base. The two enclosure brackets should be
installed on the front of the unit. The two panel brackets
should be installed on the rear of the unit.
Left
Enclosure
Bracket
Installing the Brackets
NOTE: Enclosure brackets support the front enclosure and
the side panels. Panel brackets only support the side
panels.
2. Install the front enclosure.
a. Slide weld screws into the T-slot.
Place the weld screws into the
approximate position to align with the
holes in the front enclosure.
b. Position the bottom of the front enclosure into the two
enclosure brackets.
c. Align the weld screws with the holes in the top of the
front enclosure and support trim. Secure using the
supplied cap nuts. Do not over-tighten the cap nuts.
T-Slot
Cap Nut
Installing the Front Enclosure
Panel
Bracket
Right Enclosure
Bracket
Foot
Weld Screw
T-Slot T-Slot
Support
Trim
3. Install the side panels. To install each side panel:
a. Remove the screw on the top of each support post.
b. Position the side panel in the panel bracket and the
enclosure bracket. Make sure the side panel sits under
the front enclosure.
c. Attach the upper bracket to the top of the support posts
using the previously removed screws.
Upper
Bracket
Enclosure
Bracket
Installing the Front Enclosure and Side Panel
Side Panels
Two plastic side panels are available as an option for all GRBW
models. Use the following procedure to install each side panel.
1. Attach the four panel brackets to the bottom of the unit.
a. Unscrew the four feet or legs from each corner of the
unit
b. Screw the feet or legs through the appropriate bracket
and into the base.
NOTE: The four panel brackets must be installed in the proper
location and orientation. Refer to the illustration for
proper bracket installation information.
2. Position the side panels in the panel brackets.
3. Attach the two upper brackets to the top of each side of the
unit using supplied screws.
Upper
Bracket
Foot
Installing the Side Panel
12
English
Support
Post
Panel
Bracket
Side
Panel
Panel
Bracket
GRBWM-1122