Advertisement
Available languages
Available languages
Warning
Do not expose the human eye direct to laser beam.
Before using this unit make sure the power supply is grounded.
This unit is intended for indoor use only and should be kept away from water,
moisture and shakes. The working temperature of this unit is 18-30°C
Use a cleaning tissue to remove periodically the dust on mirrors.
Always replace with the exact same type fuse, replacement with anything other
than the specified fuse can cause fire or electric shock and damage your unit,
and will void your manufactures warranty.
Unplug the unit from the mains prior to cleaning or repairing it.
All repairs must be carried out by a qualified technician. Do not try to repair the
unit yourself. It doesn't contain any user serviceable parts.
Do not use the unit if the mains lead is damaged. A damaged mains lead must
be immediately replaced by a qualified electrician. Do not try to replace the
mains lead yourself.
DMX512
1. Install the units in a suitable position (laying or appending).
2. Use standard XLR microphone cable chain your units together via the XLR
connector on the rear of the units. For longer cable runs we suggest a terminator
at the last fixture.
3. Assign a DMX address to each the unit.
4. Turn on all units' power, the units begins reset, then the unit begins working.
5. Use DMX console to control your units.
DMX address calculation
Before using the DMX512 controller, you should set the channel address. The
address can be set from 001 511. Every binary address switch has a digital
number. Please refer to:
©Copyright Lotronic 2012
GREEN-100
DESCRIPTION
6)
DIP SWITCH
Dip switch are use to select operating mode ( DIP switch 10 ) and to set the DMX address
( DIP switch 1 to 9 )
-
When DIP switch 10 is in ON postion, operating mode is DMX. Use DIP switch 1 to 9 to
set address
Some examples of DMX address setup :
-
When DIP switch 10 is in OFF position, use DIP switch 1, 8 and 9 to select operating
mode between sound mode, auto modes
-
1)
AC POWER INPUT / OUTPUT
Connect on this AC power input your AC cord
and use the AC power output to link several
GREEN-100
2)
DMX INPUT / OUTPUT
Connect on the DMX input your DMX
controler and use DMX output to link several
DMX devices
3)
MUSIC LED
This led give you an information about sound
control. It light when mic detect sound
4)
MIC
The mic is used to control laser projector in
sound operating mode
5)
MIC SENSITIVITY CONTROL
This control is used to adjust sensitivity of
mic when you use GREEN-100 in sound
mode
2
Advertisement
