Table of Contents
Advertisement
7 How to Pair a Sensing Device to a Layer N Gateway
Refer to either the Wireless Pairing or Wired Pairing instructions as applicable.
7.1
Wireless Pairing
Pairing your wireless Smart Interface (IF-006) or Smart Sensor is made easy with a one-button pairing system between
the IF-006 or Smart Sensor and the Layer N Gateway.
Important:
The pairing instructions for the SS-001-RUG differ from the standard wireless pairing procedure.
Refer to section 7.1.1 SS-001-RUG Pairing to pair an SS-001-RUG to your Layer N Gateway.
Step 1: Push the pairing button once on your Smart Sensor or IF-006 device. The LED Status Indicator will blink green
indicating it is in Pairing Mode.
Step 2: Quickly push the pairing button on the Layer N Gateway. The LED on the Gateway will blink green indicating
the Gateway is in Pairing Mode.
When the IF-006 or Smart Sensor has been successfully paired to the Layer N Gateway, the LED will stop
blinking on both devices.
SS-001-RUG Pairing
7.1.1
To pair an SS-001-RUG sensor to a Layer N Gateway, follow the instructions below:
Step 1: Locate the small pinhole on the underside of the SS-001-RUG unit and insert a paperclip to press
Step 2: Quickly push the pairing button on the Layer N Gateway. The LED on the Gateway will blink green
When the SS-001-RUG has successfully been paired to the Gateway, the LED status indicator will briefly
flash orange before flashing green one more time.
Note:
the button once. The LED Status Indicator at the top of the unit will blink green once when
successfully completed.
indicating the Gateway is in Pairing Mode.
Holding the pinhole button on the underside of the unit for longer than 5 seconds will reset the
sensor to its factory default settings.
19 |
M 5 7 9 0
Advertisement
Table of Contents
