Connecting The Cables - Cisco Flex 7500 Series Installation Manual

Wireless

Hide thumbs Also See for Flex 7500 Series:

Deployment manual (126 pages)

Table of Contents

Chapter 1

Cisco Flex 7500 Series Wireless Controller Installation Guide

Read the safety information in

Step 1

Touch the static-protective package that contains the hot-swap power supply to any unpainted metal

Step 2

surface on the controller; then, remove the power supply from the package and place it on a

static-protective surface.

Remove the failed power supply first. Grasp the handle on the rear of the power supply and slide the

Step 3

power supply out from the chassis.

Power

supply

release tab

Grasp the handle on the rear of the power supply and slide the power supply forward into the

Step 4

power-supply bay until it clicks. Make sure that the power supply connects firmly into the power-supply

connector.

Route the power cord through the handle so that it does not accidentally become unplugged.

Step 5

Connect the power cord for the new power supply to the power-cord connector on the power supply.

Step 6

Connect the other end of the power cord to a properly grounded electrical outlet.

Step 7

Make sure that the ac power LED and the dc power LED on the ac power supply are lit, indicating that

Step 8

the power supply is operating correctly. The two green LEDs are to the right of the power-cord connector.