Listen LT-700 User Manual page 31

LT-700 Troubleshooting continued
The audio doesn't have much fidelity
If your receivers all have SQ capability, activate SQ in all units by moving their switches to the
ON position. In the LT-700 and all SQ-equipped receivers, the SQ switch is located inside the bat-
tery compartment. See page 20 for more information.
There is too much noise
This is most likely because the microphone is not close enough to the talker's mouth, and it is pick-
ing up background noise. Try positioning the microphone closer or try using a microphone that is
directional (such as a head-worn mic). If you are using a narrow band channel, try switching to a
wide band channel. Try another setting on the mic sensitivity switch (located inside the battery
compartment). Ensure the microphone is not brushing up against anything. See page 8 for more
information.
There is interference
Try different frequencies until you find a clear channel. If this does not work, try a different fre-
quency band (i.e. if you are using 72MHz equipment, exchange it for 216MHz equipment). This is
done by returning the equipment to Listen (no charge) and swapping it for the alternate frequency
band equipment.
I cannot pick up the signal on the receiver
Make sure the transmitter and the receiver are on the same frequency band (72MHz or 216MHz)
and channel.
I can pick up the signal on the receiver, but it sounds like it's not tuned in
Check to make sure the transmitter and receiver are on exactly the same channel number / letter.
If using another brand of receiver refer to Listen's Frequency Compatibility Tables on pages 22-25).
27