Table of Contents
Advertisement
Installation
Your Detector
Intro
Operation
Customer
Warranty
Assistance
Dashboard Mounting
1.
Place the detector on the dashboard to find a location
where the unit has a clear, level view of the road.
Secondary Icons
The angle can NOT be adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
Notice
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and
reattach the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle's
cigarette lighter.
4
English
Getting Started
Your Detector
Intro
Operation
Customer
Warranty
Getting Started
Assistance
On-Off/
Volume Control
Rotate clockwise
Secondary Icons
(away from you)
To Turn On the Unit and Adjust the Audio Volume
Notice
Rotate the On-Off/
Tone
Visual Display
Volume control
Three beeps
Testing
clockwise (away
from you).
System Ready
The display will then
cycle through the
user mode settings
(city or highway,
Intellimute and
Main Icons
SmartPower status).
Start-up is complete when the display continuously shows the
current compass direction (N, NE, E, SE, S, SW, W or NW) plus
single letters indicating current user mode settings (c = City
mode, City X Beep Off mode and City X+K mode, h = Highway
Intro
Operation
Customer
Warranty
mode, i = IntelliMute on).
Assistance
Power On
Start-Up Complete
Testing
NW
h
Secondary Icons
System Ready
NOTE
In some vehicles, power is supplied to the cigarette
Notice
lighter even while the ignition is off. If this is the case
Voice Alert
with your vehicle and you have turned the SmartPower
off, you should turn off or unplug your detector when
parking for lengthy periods. Cobra recommends leaving
SmartPower at the factory setting, which is on.
Nothing Comes Close to a Cobra
•
Voice
Testing, then three
beeps
System Ready
Voice Alert
®
5
Advertisement
Table of Contents
