Advertisement
G. Enter the name of the SSID (Service Set Identifier) for your Ad- Hoc or
Infrastructure setting. The SSID must be identical for all points in the net-
work. The default setting is linksys (all lowercase.) Click Next.
G
H. The InstallShield Wizard will ask you to review your settings before start-
ing to copy files. Click Back to review or change any settings. Click
Next if you are satisfied with your settings.
H
I. The InstallShield Wizard will begin copying the files. The bar in the mid-
dle of the dialog box shows the percentage of the files that are copied.
I
J. The screen below might appear next. Click on the Yes button if you want
to continue the installation. Click on the No button if you want to cancel
the installation.
J
K. You will see this screen when the Wireless PC Card Setup Wizard has
been successfully installed.
K
The software installation is complete. For setup information or any
other questions, refer to the product's User Guide.
Installing the Wireless PC Card
Note: Make sure to install the software before you install the Wireless
PC Card.
A. Locate an available Type II or Type III PCMCIA CardBus slot on your
notebook computer.
B. With the Wireless PC Card's 68-pin connector facing the PCMCIA
CardBus slot and the "Wireless PC Card" label facing up, as shown below,
slide the Wireless PC Card completely into the PCMCIA CardBus slot.
B
C. You may see several screens appear as the driver installation is finalized. This
is normal. No input should be necessary, and the screens should disappear
when the card is ready for use.
Note to Windows 2000 Users: You may be prompted at this time
that a digital signature has not been found; this is normal. The
WPC54A has been verified to run on Windows 2000. Click Yes
to continue, and then click the Finish button to end the hardware
detection process.
Installation of the Wireless PC Card
is complete. For setup information or any other
questions, refer to the User Guide.
QI-WPC54a -032902NC BW
W W W . L I N K S Y S . C O M
Advertisement
