X-Rock MAUI Owner's Manual page 6

320x80x15cm all- around inflatable stand up paddle board
Table of Contents

Advertisement

PADDLE ASSEMABLY
The paddle consists of 3 sections: the handle, the shaft, and the blade.
The shaft is symmetric, so it doesn't matter which end connects to the
blade. To connect the blade and the shaft, first open the clip on the
buckle. Align the spring ball on the blade with the lock hole on the shaft,
then insert the blade into the shaft and make sure the spring ball locks in
the hole (a). Close the clips on the buckle to secure the connection. For
the handle there is no spring ball. Simply use the buckle to secure the
handle. If the buckle becomes loose, open the clip and rotate clockwise to
tighten the connection (b).
LEASH INSTALLATION
Affix one end of the leash to the back d-ring on the board, and the other end to your body.
ALWAYS WEAR A LEASH WHEN PADDLING!
DEFLATION
1) To deflate, open the valve cap and push the valve pin down to open the high-pressure valve.
2) After most air has emitted, use the pump to extract the remaining air. To do so, attach one end of the pump hose to the IN port,
and the other end to the high-pressure valve. Pump till the board is fully deflated, detach the hose, push the valve pin to close the
valve, and then close the cap.
IF THE BOARD IS EXPOSED TO THE HOT SUN, CHECK THE PRESSURE AND MAKE SUR IT'S NOT OVERPRESSURED.
DEFLATE SLIGHTLY IF NECESSARY.
STORAGE
1) Clean and check the board and all the accessories after each use. Rinse it thoroughly with clean water and make sure to remove any
residues or salt if used in salt water. Do not use detergents or any type of silicone-based products. Make sure the product is completely
dry before putting away.
2) Roll it up from the tail. put it into the backpack. Rolling from the tail can contain the fin boxes and clips inside the wrap, which will
provide better protection than exposing them to the outside.
3) When storing your board, keep it in a clean and dry place that is not affected by major variations in temperature and other damaging
factors. You may store it. deflated and rolled up in a bag or assembled and lightly inflated (not subject to deformations). Store it away
from rodents.
DO NOT STORE THE BOARD AT A TEMPEARTURE BELOW 0
PERMANET DAMAGE.
WARNING!
CAUTION!
CAUTION!
°C
/ 32 F . IT WILL DETERIORATE THE MATERIAL AND CAUSE
www.x-rock.co.uk
instagram: xrock_sup
(a)
(b)

Advertisement

Table of Contents
loading

Table of Contents