Fin Installation - X-Rock MAUI Owner's Manual

ASSEMBLY/DISASSEMBLY
DO NOT USE SHARP TOOLS!
ANY USE OF AIR GOMPRESSORS WILL DAMAGE YOUR PRODUCT AND VOID ALL WARRANTIES.
FOR FIRST INFLATION, IT IS RECOMMENDED TO INFLATE INDOOR AT ROOM TEMPERATURE WHERE THE BOARD
MATERIAL IS SOFT AND THE ASSEMBLY PROCESS IS EASIER.
Choose a smooth and clean surface to unfold your product.
INFLATION
1) The board is equipped with a high-pressure valve. To inflate, first open the cap by turning it counterclockwise. Check and make sure
the valve is in closed position. To verify that, push the pin down. If the pin stays down, you have now opened the valve. To close it, push
the pin again so it springs back up. Now the valve is closed. Inflation is done in the CLOSED position (pin UP), and deflation is done in the
OPEN position (pin DOWN).
PIN UP- VALVE CLOSED
2) The pump has two ports: the OUT port and the IN port on the handle. The OUT port is for inflation, and the IN port is for deflation.
Attach one end of the pump hose to the OUT port, and the other end to the high-pressure valve. Push the hose fitting into the valve
and turn clockwise to lock the position. Inflate until the desired pressure is reached the recommended pressure (12 to 15 psi). After
inflation, disconnect the hose and close the cap. The valve won't be airtight until the valve cap is closed.
3) Read the instructions on the pump body about single action pumping and double action pumping. First pump in double action mode to
generate large volume of air at low pressure. When you feel pumping becomes heavy, switch to single action and inflate to the desired
pressure. Check board pressure with the gauge on the pump. Do not over-inflate the board. The recommended pressure for typical use is
12 to 15 psi.

FIN INSTALLATION

After inflation, install the center fin on the bottom of the board. Insert the one side of the fin into the box (a), and then push the fin into the
box to make sure it's fully inserted. After the fin is completely install into the box, put the small insert into the opposite groove for fixing (b).
WARNING!
(a)
www.x-rock.co.uk
instagram: xrock_sup
PIN DOWN- VALVE OPEN
(b)