Summary of Contents for X-Rock MAUI
- Page 1 OWNER’S MANUAL www.x-rock.co.uk instagram: xrock_sup 320x80x15cm ALL - A ROUN D INFLATABLE STAND UP PADDLE BOARD www.x-rock.co.uk instagram: xrock_sup...
-
Page 2: Dear Customer
NOT COMPLY WITH THE INSTRUCTIONS. WARNING! WARNING! REMINDS YOU OF SAFETY MEASURES WHICH MUST BE OBSERVED. DENOTES ALSO UNSAFE PRACTICES WHICH COULD RESULT IN INJURY OR PRODUCT OR PROPERTY DAMAGE IF YOU DO NOT COMPLY WITH THE INSTRUCTIONS. www.x-rock.co.uk instagram: xrock_sup... -
Page 3: General Safety
WARNING! IT IS THE OWNER'S RESPONSIBILITY TO MAKE SURE THAT ALL USERS WILL CAREFULLY READ AND FOLLOW THE MANUAL AND INSTRUCTIONS FOR THE SAFE OPERATION OF THIS PRODUCT. OBSERVE ALL LOCAL AND NATIONAL LAWS. www.x-rock.co.uk instagram: xrock_sup... -
Page 4: In The Package
TECHNICAL SPECIFICATION MODEL LENGTH WIDTH THICKNESS WEIGHT VOLUME LOAD 320x80x15CM 10.6FT/320CM 31IN/80CM 6IN/15CM 18.7LB/8.5KG 275 L 297LB/135 KG 1 CARRY HANDLES 3 D-RINGS 2 BUNGEE CORD 4 EVA PAD 5 AIR VALVE 7 SIDE FINS 6 CENTER FIN www.x-rock.co.uk instagram: xrock_sup... -
Page 5: Fin Installation
After inflation, install the center fin on the bottom of the board. Insert the one side of the fin into the box (a), and then push the fin into the box to make sure it's fully inserted. After the fin is completely install into the box, put the small insert into the opposite groove for fixing (b). www.x-rock.co.uk instagram: xrock_sup... - Page 6 You may store it. deflated and rolled up in a bag or assembled and lightly inflated (not subject to deformations). Store it away from rodents. CAUTION! DO NOT STORE THE BOARD AT A TEMPEARTURE BELOW 0 °C / 32 F . IT WILL DETERIORATE THE MATERIAL AND CAUSE PERMANET DAMAGE. www.x-rock.co.uk instagram: xrock_sup...
- Page 7 SOME TIPS FOR BEGINNERS ·Look forward horizontally. Do not look into the water. ·Keep paddling. Your paddle is another supporting point for keeping balance. ·When adjusting your paddle, make the handle 9'' or armlength overhead. www.x-rock.co.uk instagram: xrock_sup...
-
Page 8: Troubleshooting
2) Clean the damaged area and the corresponding side of the patch with a grease remover and allow it to dry for 5 minutes. 3) Apply 3 thin layers of glue on both the damaged area and the patch and allow each layer to dry for 5 minutes until the glue feels tacky. www.x-rock.co.uk instagram: xrock_sup... - Page 9 , please visit our website: www.xrock.co.uk WARNING! YOUR PRODUCT IS DESIGNED IN ACCORDANCE WITH THE STANDARDS FOR A SPECIFIC USE. ANY MODIFICATIONS OR EXCESSIVE USES COULD RESULT IN SERIOUS RISKS FOR THE USER AND WILL VOID THE WARRANTY. www.x-rock.co.uk instagram: xrock_sup...