Advertisement
time, the receiver will keep vibrating.
5. Up and Down buttons: These two keys can be used to adjust the sounding and vibration
frequencies of the beep and vibration buttons, with level 00 being the static mode, level 1 being
the minimum level, and level 10 being the maximum level.
6. Flashlight button: This button is used to light up or turn off the headlight.
Operating instructions for the receiver:
1. Power button: The receiver powers on (the red indicator light is on) when the button is
pressed and powers off (the indicator light goes off as well) when the button is pressed and held
down for 1.5 seconds. The receiver must be turned off when not in use. If left on standby for a
long time, the battery will run out quickly, and its service life will also be affected.
2. Channel selection: The three channels of the receiver are distinguished by three different
light colors, with CH1 corresponding to the red light of the receiver, CH2 corresponding to the
green light of the receiver, and CH3 corresponding to the blue right of the receiver. To switch to
the next channel, you shall press and hold down the channel selection button for three seconds,
and so on.
3. Charging port: The waterproof silica gel plug shall be lifted gently so that the charging
cable can be inserted for charging (be sure not to break off the waterproof silica gel plug). After
the charging is completed, the plug shall be restored immediately to prevent water from entering
and causing a short circuit.
4. Collar installation: The collar belt shall be passed through the collar holders at both ends of
the receiver and stretched to an appropriate size (see the diagram).
Suggestions for use of the trainer:
1. This product is used for pet training and recalling a pet back from a distance by voice
commands when the pet cannot be seen. Through appropriate training with the trainer, your pet
will be able to understand and obey your commands. Voice commands allow your pet to quickly
develop good habits based on your daily language habits. However, the vibration mode and beep
sound function can only see good effects after a period of time. Please follow the instructions to
use the functions one by one.
2. Before training with the transmitter, you shall place the receiver together with the collar
around the neck of the pet. No electronic function shall be used at the beginning so that the pet can
adapt and accept the collar.
3. In the early days of using the trainer, a pet may look irritable and upset as it has never
experienced such stimulation before. For this reason, we recommend using a leash to take control
of the pet and keep away from people and other animals during the period to avoid accidents.
4. We recommend you start with voice command training first so that the pet can get used to,
accept, and execute your commands. Then, you can use the beep mode to warn or stop the pet's
misbehaviors and, through combined use with the voice command function for repeated training,
make the pet understand what behaviors are not allowed. The vibration function is used to stop
more serious or incorrigible misbehaviors and give reminders. During use of the vibration and
beep sound functions, you may custom how to use the trainer according to your own habits. You
are recommended to start with the minimum vibration and beep sound levels in the initial period
and turn them up over the training time so that good effects can be presented. If during the use a
Advertisement
