Advertisement
1. The unit comes with a built-in rechargeable battery, a charging port under a waterproof
silica gel plug (as shown in the functional diagram), and a USB charging cable (the transmitter
and the receiver share one charging cable).
2. The unit must be fully charged when used for the first time. As the unit is waterproof, the
waterproof silica gel plug shall be lifted gently for charging (be sure not to break off the
waterproof silica gel plug) and restored to a state free of any gap immediately after the charging is
completed. The charging indicator light is red when the charging is ongoing and turns green after
it is completed.
3. The unit has a power button (as shown in the figure). It powers on (the red channel
indicator light is on) when the power button is pressed and powers off (the indicator light goes off
as well) when the button is pressed and held for 1.5 seconds. It must be turned off when not in use.
If left on standby for a long time, the battery will run out quickly.
4. The unit shall be charged timely when the red indicator light flickers to prompt low battery.
Long-time under-voltage operating will cause damage to the battery.
Wearing the receiver:
When leaving the factory, the receiver comes with a collar (the collar is adjustable up to
67cm and suitable for all pets; a part of it may be cut off if it looks too long). For the wearing of
the receiver, the belt of the collar shall be passed through the collar holders at both ends of the
receiver (as shown in the figure) and placed around the neck of the pet. Make sure to put the
channel and charging indicator light in front of the pet so that it is convenient to observe the
channel and power indication. Once again, the receiver shall be turned off timely when not in use.
Function indication of the display screen:
Channel selection icon: Three channels are selectable (for remote control, the selected
channel shall agree with the frequency band of the receiver), with CH1 corresponding
to the red light of the receiver, CH2 corresponding to the green light of the receiver, and CH3
corresponding to the blue right of the receiver.
Battery power icon: It displays the power of the battery in real time.
Call icon: It shows up when the transmitter is used to talk to the pet in real time.
During a call, the call button must be pressed and held down.
Vibration icon: It shows up when the vibration button is pressed. Ten levels of
vibration (00 is the invalid state) are selectable by pressing the "+" and "-" buttons.
Advertisement
