Measuring Functions - KDS KLM-1P Instructions Manual

Switching On and Off
To switch on the measuring tool in line operation, push the
On/Off switch 1 to the " " position and in point operation
to the " " position. Immediately after switching on, the
measuring tool sends a laser beam out of outlet opening 5
(line operation) or 11 (point operation), depending on the
selected operating mode.
Do not point the laser beam at persons or animals and
do not look into the laser beam yourself, not even from
a large distance.
To switch off the measuring tool, push the On/Off switch 1
to the centre position.
Do not leave the switched on measuring tool unattend-
ed and switch the measuring tool off after use. Other
persons could be blinded by the laser beam.
When not using the measuring tool, switch it off in order to
extend the battery life.

Measuring Functions

Note: The specified levelling accuracy applies for the
alignment of the laser beam with reference to the spirit
levels 3 and 4.
Positioning the Measuring Tool (see figure B)
For precise alignment with the spirit levels, the position of
the measuring tool is important.
The listed levelling accuracy is only achieved when the
measuring tool is properly positioned:
-- For horizontal alignment with spirit level 4, the laser outlet
opening for line operation 5 must be horizontal and the
aluminium supporting surface 2 of the measuring tool
must face downward.
28