Working Advice - KDS KLM-1P Instructions Manual

Working Advice

For marking, always use only the centre of the laser
point or the laser line. The size of the laser point as well
as the width of the laser line change with distance.
Fastening/Aligning with the Wall Holder
With the wall holder 12, the measuring tool can be fastened
as follows:
Line operation: Place the wall holder via its recess on the
--
backside onto a screw head slightly projecting out of a
wall. Fasten the measuring tool with the magnets 9 to the
metal surface for line operation 13 of the wall holder. Turn
the upper part of the wall holder to align the measuring
tool as required.
Point operation: Place the wall holder via the tripod
--
mount 16 onto the 1/4" male thread of the tripod and
screw the locking screw of the tripod tight. Align the tri-
pod roughly. When working without tripod, place the wall
holder on a surface that is as horizontal as possible.
Position the measuring tool with the aluminium supporting
surface 2 facing down on the wall holder. Attach it via the
left magnet 9 (viewed from the front side of the measuring
tool) to the metal surface for point operation 14 of the wall
holder.
Horizontally align the upper part of the wall holder with
adjusting screw 15 of the wall holder and spirit level 4 of
the measuring tool. Turn the upper part of the wall holder
by 90° and repeat the alignment.
31