Napoleon T495SBN Installation Manual page 32

32
4 x Z570-0027 (1/4-20 X 3/8")
6. Grill Head Installation
To avoid assembly difficulties, prior to mounting the grill head, remove zip tie holding regulator/connector up under control
panel. This was installed at the factory to protect the regulator hose during shipping and is no longer required. (Take care
when removing the tie not to damage the hose).
Lift grill head and place on assembled cart, lining up holes in top of side cart panels with holes in bottom of base. Fasten
from inside using (4) 1/4-20 x 3/8" screws, two per side.
Two people are required for this step.
Correct Assembly
www.napoleongrills.com
2 x Z570-0022 (M4X8mm)
Incorrect Assembly
3/8"(10mm)