Product Description - Oase Varionaut 270 DMX/02 Operating Instructions Manual

- EN -
• Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, if in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical changes to the unit.
Information about these operating instructions
Welcome to OASE Living Water. Thank you for making a great decision and choosing our product Varionaut 270
DMX/02, Varionaut 400 DMX/02.
Prior to commissioning the unit, please read the instruction manual carefully and fully familiarise yourself with the unit.
Ensure that any work on or with this unit is carried out according to this manual.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place. Please also hand over the instructions when passing the unit on to a new
owner.
Warnings used in these instructions
Warnings
The warning information is categorised by signal words, which indicate the extent of the hazard.
W A R N I N G
• Indicates a possibly hazardous situation.
• Non-observance may lead to death or serious injuries.
C A U T I O N
• Indicates a possibly hazardous situation.
• Non-observance may lead to slight or minor injuries.
N O T E
Information for the purpose of clarification or for preventing possible damage to assets or to the environment.
Cross-references used in these instructions
 A reference to a figure, e.g. figure A.
Reference to another section.
→

Product Description

 A Varionaut 270 DMX/02, Varionaut 400 DMX/02
1 Pump casing
− The position of the outlet can be changed by fitting the pump casing rotated through 90°.
2 Outlet (pressure socket)
3 Inlet (suction socket)
4 Filter housing
5 Stand
− Ensures secure and stable positioning of the pump.
− Can be firmly bolted to the ground.
6 DMX line connection
Important: Moisture at the connections can damage the pump.
− Only remove the protection caps for connecting the DMX lines.
− Ensure that the rubber seals are clean and fit exactly.
− Replace damaged rubber seals.
18