Download
Share
Print this page
Candy CFT611NS/S Instruction Manual
  1. Manuals
  2. Brands
  3. Candy Manuals
  4. Ventilation Hood
  5. CFT611NS/S
  6. Instruction manual

Candy CFT611NS/S Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
 
 
 
 
CFT611NS/S 
Cooker Hood 
Instruction Manual
 
 
 
 
 
 
1
 
 

Advertisement

loading
Need help?

Need help?

Do you have a question about the CFT611NS/S and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Candy CFT611NS/S

Summary of Contents for Candy CFT611NS/S

  • Page 1     CFT611NS/S  Cooker Hood  Instruction Manual                    ...

  • Page 2: Table Of Contents

    Content Safetyinstructions…………………………………..……………………………………………………3 Installation…………………………………..……………………………………………………………….5 Startusingyourcookerhood…………………………………..…………………………………..8 Troubleshooting…………………………………..………………………………………………………8 Maintenanceandcleaning…………………………………..……………………………………….9 Environmentprotection…………………………………..……………………………………………12...

  • Page 3: SafetyInstructions

    SAFETY INSTRUCTIONS  hismanualexplainstheproperinstallationanduseofyourcookerhood, pleasereaditcarefullybeforeusingevenifyouarefamiliarwiththeproduct. Themanualshouldbekeptinasafeplaceforfuturereference. Nevertodo: Alwaystodo: ● ● o not try to use the cooker hood mportant! Always switch off the without the grease filters or if the filters electricity supply at the mains during are excessively greasy! installation and maintenance such as light bulb replacement.
  • Page 4 Alwaystodo: Alwaystodo: ● ● lways put lids on pots and pans aution: The appliance and its when cooking on a gas cooker. accessible parts can become hot during operation. Be careful to avoid ● hen in extraction mode, air in the touching the heating elements.

  • Page 5: Installation

    INSTALLATION(VENT OUTSIDE)   If you have an outlet to the outside, your cooker hood can be connected as below picture by means of an extraction duct (enamel, aluminum, flexible pipe or non- flammable material with an interior diameter of 120mm) Before installation, turn the unit off. Method A(Wall Mounting): 1.
  • Page 6 Method B(Cabinet Mounting): 1. Drill 4 holes of Ø 6mm at the bottom of the hanging cupboard.See pic 4. 2. Install the cooker hood on the bottom of the cupboard, tighten the cooker hood with the included M4 screws + flat washers. 3.
  • Page 7 Electrical Installation All installation must be carried out by a competent person or qualified electrician. Before connecting the mains supply ensure that the mains voltage corresponds to the voltage on the rating plate. Direct Connection The appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum opening of 3mm between the contacts.

  • Page 8: StartUsingYourCookerHood

    Start Using Your Cooker Hood Toggle switch There are 3 speeds for the motor and on / off switch for the lamp. Slide the switch for operation. Motor Operation Low Power Setting Mid Power Setting High Power Setting Light Operation TROUBLESHOOTING  Fault  Possible Cause  Solution  Fan switch turned off Select a fan switch position.

  • Page 9: MaintenanceAndCleaning

    MAINTENANCE AND CLEANING Caution: • Before maintenance or cleaning is carried out, the cooker hood should be disconnected from the mains power supply. Ensure that the cooker hood is switched off at the wall socket. • External surfaces are susceptible to scratches and abrasions, so follow the cleaning instructions to ensure the best possible result is achieved without damage.
  • Page 10  Installing grease mesh filter To install filters for the following four steps . - Angle the filter into the slots at the back of the hood. - Push the button on the handle of the filter. - Release the handle once the filter fits into a resting position. - Repeat to install all filters.
  • Page 11 NOTE:  Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.  When activated carbon filter attached, the suction power will be lowered. BULB REPLACEMENT  The bulb must be replaced by the manufacturer, its Important : service agent or similarly qualified persons.

  • Page 12: EnvironmentProtection

    ENVIRONMENTAL PROTECTION:  This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2012/19/EU.