Advertisement
Advertisement
Related Manuals for Candy CBT6130/2W-07
Summary of Contents for Candy CBT6130/2W-07
- Page 1 CBT6130/2W-07 CBT6130/2N-07 CBT6020/2X-07 Instruction manual...
-
Page 2: Table Of Contents
CONTENT 1………………………………………. Introduction 2………………………………………. Safety precaution 3……………………………………….. Installation instructions 4……………………………………….. Operation 5…………………………………………Use and maintenance 6 …………………………………………Trouble shooting 7…………………………………………Environmental protection... -
Page 3: Safety Precaution
INTRODUCTION Thank you for choosing this cooker hood. This instruction manual is designed to provide you with all required instructions related to the installation, use and maintenance of the appliance. In order to operate the unit correctly and safety, please read this instruction manual carefully before installation and usage. - Page 4 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. The instructions shall state the substance of the following: – there shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas other...
- Page 5 The installation instructions shall include the substance of the following: – the air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room);...
- Page 6 attach an accessory such as a facia or duct fitting. Where fixing or mounting screws, or other fixing devices are used, that penetrate into the range hood with an accessible metallic enclosure of class II construction, to attach an accessory, the instructions shall indicate the required location of these screws or fixing devices and include the substance of the following warning.
-
Page 7: Installation Instructions
Regarding the instructions method of fixing for the fixed appliance and how the appliance is to be fixed to its support, thanks to refer to the section “INSTALLATION AND FIXING”. Regarding the instructions for the bulb changing, thanks to refer to the section “light changing”. - Page 8 4.1.2 Insert the wall plugs into the holes. 4.1.3 Insert the screws into the wall pulgs and tight the screws. 4.1.4 Put up the cooker hood onto the fixed screws. 4.1.5 Put the one air outlet and extensible pipe onto the cooker hood. (the extensible pipe is optional not supplied) Way two: (See Pic 2B) 4.2.1 Drill 6 holes of 4mm diameter at the bottom of the hanging cupboard...
-
Page 9: Operation
For safety reason, please use only the same size of fixing or mounting screw which are recommended in this instruction manual. Warning: Failure to install the screws or fixing device in accordance with these instructions result electrical hazards 4. -
Page 10: Use And Maintenance
5. USE AND MAINTENANCE It is recommended to operate the appliance prior to cooking. There shall be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels(not applicable to appliances that only discharge the air back into the room. - Page 11 exhausting fumes from appliance burning gas or other fuels. Regulations concerning the discharge of air have to be fulfilled. The details concerning the method and frequency of cleaning. In order to prevent fire hazard, it is recommendable to clean the filter at a maximum of 2 months by carrying out the followings: -Unplug before cleaning, then remove the filters from the cooker hood and wash them in a solution of water and neutral liquid detergent,...
- Page 12 instruction. Replace the lamp pls see pic 5 ILCOS D code for this lamp is: IBB/C-40-230-E14-35 Carbon filter (not supplied) Carbon filter can be used to trap odors. Normally the activated carbon filter should be changed at three or six months according to your cooking habit. Activated carbon filter cannot be washed or recycled.
-
Page 13: Trouble Shooting
6. Trouble shooting Problem Possible cause Solution The extractor fan ceases to The kitchen hood feed cable is Connect feed cable function. not connected to the network. network. There is no electrical current in Check that the network has the network. electrical current. -
Page 14: Environmental Protection
7.ENVIRONMENTAL PROTECTION: This product is marked with the symbol on the selective sorting of waste electronic equipment. This means that this product must not be disposed of with household waste but must be supported by a system of selective collection in accordance with Directive 2002/96/EC. It will then be recycled or dismantled to minimize impacts on the environment, electrical and electronic products are potentially dangerous for the environment and human health due to the presence of hazardous...
Need help?
Do you have a question about the CBT6130/2W-07 and is the answer not in the manual?
Questions and answers