Mechanical Instructions - Philips MG3.2E Service Manual

EN 24 4.

4. Mechanical Instructions

Index of this chapter:
1. Set Disassembly
2. Service Positions
3. Board Removal
4. Set Reassembly
Note: Figures below can deviate slightly from the actual
situation, due to different set executions.
4.1 Set Disassembly
Follow the disassemble instructions in described order.
4.1.1 Wireless Surround Transmitter Removal (if attached)
Transmitter module
2
A
1
Figure 4-1
1. Remove the cable [1] of the Wireless Surround Transmitter
box (at the left side of this RJ45 plug you can find the
release-hook of the lock-mechanism).
2. Pull the Wireless Surround Transmitter box backwards. It
is clicked to the rear cover via three clamps [2].
4.1.2 Rear Cover Removal
Rear view
1
3
Figure 4-2
Warning: disconnect the mains power cord before you remove
the rear cover.
First, remove the top cover (= plate with 'saucer'):
1. Remove the three fixation screws [1] that hold the cover
plate.
2. Pull the cover (horizontally) backwards.
MG3.2E Mechanical Instructions
2
2
CL 16532149_060.eps
3
1
1
CL 16532149_061.eps
2
061201
To be able to access the electronics of the set, you must
remove the rear cover:
1. Remove the three remaining fixation screws [2] of the I/O-
cover plate.
2. Remove the remaining fixation screws [3] at the two sides
and the top of the rear cover.
3. Now remove the rear cover. Make sure that wires and
cables are not damaged during cover removal.
4.1.3 I/O Cover Plate Removal
Cover plate
041201
It is rather easy to remove the I/O-cover plate:
1. Release the hook on the left side (pull slightly outwards).
2. Now remove the plate (it hinges at the right side).
4.1.4 Sub-woofer Removal
How to remove the sub-woofer:
1. Disconnect the loudspeaker cable at the top of the sub-
woofer box.
2. The subwoofer has two rubber feet at the bottom. Behind
them, there is a snap hook. Release this hook (pull
backwards), and at the same time pull the sub-woofer box
upwards.
3. Now remove the sub-woofer.
3
CL 96532023_003.ai
Figure 4-3
230399