Linksys EG24M User Manual page 30

Delay shows the number of seconds that must elapse before a
DHCP request broadcast is relayed to the next IP subnetwork.
Servers shows any preferred servers that have been defined.
Relays shows the outbound IP subnetwork for relaying a DHCP
request broadcast.
The following procedure describes how to change the DHCP gateway set-
tings. As part of this procedure, you can specify up to three preferred servers
and/or an outbound relay interface.
1. Highlight the appropriate VLAN ID and press Enter. A screen similar
to the following will appear.
2. To add a relay IP, hold down the Shift key and press the "+" key. A screen
similar to the following will appear.
3. Highlight the appropriate interface, or highlight All Interfaces, then press
Esc. A screen similar to the following (see next page) will appear.
52
Linksys EtherFast II Series
®
10/100 Managed 24-Port GigaSwitch
4. With the highlight on DHCP Gateway, press Enter. The following screen
will appear.
5. Highlight Enabled and press Enter to enable the DHCP gateway.
6. Press the Down Arrow key and press Enter to configure the maximum
number of hops. When the following screen appears, type the desired num-
ber and press Enter.
7. Press the Down Arrow key and press Enter to configure the delay. When
the following screen (see next page) appears, type the delay, in seconds,
and press Enter.
53