Table of Contents
Advertisement
en Troubleshooting
Fault
Display flashes.
Malfunctions
Fault
Water is left in the appliance
at the end of the pro-
gramme.
Appliance cannot be
switched on or operated.
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
54
Cause
Appliance door is not closed
properly.
Cause
Filter system or area under
the filters is blocked.
Programme has not yet
ended.
Software update is taking
place.
Appliance functions have
failed.
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
troubleshooting
Close the appliance door.
▶
Arrange the tableware so
‒
that no parts project beyond
the basket and prevent the
appliance door from closing
properly.
troubleshooting
Clean the "Filters" → Page 41.
1.
Clean the "Wastewater pump"
2.
→ Page 56.
Wait until the programme ends or
▶
cancel the programme with Reset.
→ "Terminate programme",
▶
Page 33
Wait until the software update has
▶
finished.
Pull out the mains plug or switch off
1.
the fuse.
Wait at least 2 minutes.
2.
Connect the appliance to the power
3.
supply.
Switch the appliance on.
4.
Check the relevant fuse.
▶
Check whether the socket works.
1.
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 33
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.
Advertisement
Table of Contents
