PARKIT360 CARRIER 13K Mount Instructions

PARKIT360 CARRIER 13K Mount Instructions

Advertisement

Quick Links

CARRIER 13K
BALL MOUNT INSTRUCTIONS
VERSION 1.0
READ CAREFULLY
BEFORE OPERATION
IMPROPER USE OF THIS DOLLY CAN
CAUSE DAMAGE TO YOUR TRAILER,
PERSONAL INJURY OR EVEN DEATH.
DANGER
DANGER
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CARRIER 13K and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PARKIT360 CARRIER 13K

  • Page 1 CARRIER 13K BALL MOUNT INSTRUCTIONS VERSION 1.0 READ CAREFULLY BEFORE OPERATION IMPROPER USE OF THIS DOLLY CAN CAUSE DAMAGE TO YOUR TRAILER, DANGER DANGER PERSONAL INJURY OR EVEN DEATH.
  • Page 2 CONNECTING TO YOUR TRAILER: BALL MOUNT ADAPTER BALL MOUNT ASSEMBLY HITCH BALL Thread desired Hitch Ball into the Ball Mount. Apply a generous portion of All-Purpose Grease along the top surface of the Ball Mount Collar. The shoulder of the Hitch Ball should rest slightly above the top of the collar.
  • Page 3 HITCH BALL PLACEMENT WELD SPOTS Insert the assembled Ball Mount into the Hitch and lock as normal. Make sure the Weld Spots on the Hitch Ball are pointed towards the rear left side of your trailer at about 10 o’clock. HITCH CONNECTION FLUSH, Turn the Ball Mount Counterclockwise...
  • Page 4 CONNECTION GAP? THRUST WASHER PUZZLE PIECE with Space between the Ball Mount and Coupler? Install the Thrust Washer on top of the Ball Mount with the Puzzle Piece facing the Transformer. Tighten Ball Mount as normal. STEP DOWN HITCH? THRUST WASHER Have an obstruction preventing a flat connection? Place the Thrust Washer on top of the Ball Mount with the open section facing the trailer.
  • Page 5 ENGAGE MOTORS INTO DRIVE TURN ON THE DOLLY Pull out the Battery Power Button then Press and Hold the Power Button to turn on the Dolly. Connect the Trailer’s 7 Pin Brake Cable to the Smart Brake Plug. FREEWHEEL KNOBS Ensure the Dolly is in parking RIGHT position and ready to connect to...
  • Page 6 ALIGN THE DOLLY Using the Wireless Remote, Drive the Dolly underneath the hitch. Align the Adapter with the top of the Dolly’s Receiver Tube. INSERT ADAPTER Ensure that the Trailer is Level and the Dolly is in the Drive Position. Use the Trailer Jack Stand to fully lower the Ball Mount into the Receiver Tube.
  • Page 7 & forth slightly. Re-tighten Ball Mount. Repeat 2-3 times until you can’t tighten anymore. READY! ENSURE BALL MOUNT IS AS TIGHT AS POSSIBLE BEFORE OPERATING! PARKIT360 INC. 130 Industrial Ave, Unit 600 Carleton Place, ON K7C 3T2 Canada 1-888-926-5517 or PARKIT360.com...

Table of Contents