DSE 8721 Installation Instructions

ACCESSING THE FRONT PANEL CONFIGURATION EDITOR.

•
Ensure the engine is at rest and the module is in STOP mode by pressing the Ensure the engine is at rest and the module is in STOP mode by pressing the
Stop/Reset button. Press the Stop/Reset
simultaneously.
•
If a module security PIN has been set, the PIN number request is then shown : If a module security PIN has been set, the PIN number request is then shown :
•
Press the button the first digit will flash to enable the pin to be entered.
•
Press (up) or
•
Press (right) when the first digit is correctly entered. The digit you have
just entered will now show '#' for security.
•
Repeat this process for the other digits of the PIN number. You can press Repeat this process for the other digits of the PIN number. You can press (left) if
you need to move back to adjust one of the previous digits.
•
When is pressed after editing the final PIN digit, the PIN is checked for is pressed after editing the final PIN digit, the PIN is checked for
validity. If the number is not correct, you must re-enter the PIN.
If the PIN has been successfully entered (or the module PIN has not been enabled), If the PIN has been successfully entered (or the module PIN has not been enabled),
the editor is displayed :

EDITING A PARAMETER

•
Enter the editor as described above.
•
Press the
wish to view/change.
•
To edit the parameter, press
highlighted in blue to indicate that you are editing the value.
•
Press or
value.
•
Press to save the value. The parameter ceases flashing to indicate that it
has been saved.
•
To exit the editor at any time, press and hold the

DIMENSIONS AND MOUNTING

For flat surface mounting in a Type 1 enclosure to meet UL requirements For flat surface mounting in a Type 1 enclosure to meet UL requirements

DIMENSIONS

310.0mm x 161.5mm x 42mm
D E E P S E A E L E C T R O N I C S D E E P S E A E L E C T R O N I C S
8 7 2 1 I N S T A L L A T I O N I N S T R U C T I O N S I N S T A L L A T I O N I N S T R U C T I O N S
(down) to adjust it to the correct value.
when the first digit is correctly entered. The digit you have
or
to enter edit mode. The parameter is
down buttons to change the parameter to the required buttons to change the parameter to the required
The parameter ceases flashing to indicate that it
(12.2" x 6.4" x 1.6")
and Info buttons
to cycle to the parameter you
or button.

PANEL CUTOUT

PANEL CUTOUT
282mm x 136mm 282mm x 136
053-072
ISSUE 4
you
:
(11.1" x 5.4")