Linksys RV042 User Manual page 57

10/100 4-Port VPN Router
E-mail Addr. (USER FQDN) Authentication. The type of Local Security Gateway Type should match the Remote
Security Gateway Type of VPN devices in the other end of tunnel.
IP Only: If you select IP Only, only the specific IP Address will be able to access the tunnel. The WAN IP of the
Router will automatically appear in this field.
IP + Domain Name (FQDN) Authentication: If you select this type, enter the FQDN (Fully Qualified Domain Name),
and an IP address will appear automatically. The FQDN is the host name and domain name for a specific
computer on the Internet, for example, vpn.myvpnserver.com. The IP and FQDN must be same as the Remote
Security Gateway type of the remote VPN device, and the same IP and FQDN can be used only for one tunnel
connection.
IP + E-mail Addr. (USER FQDN) Authentication: If you select this type, enter the E-mail address, and the IP
address will appear automatically.
Dynamic IP + Domain Name (FQDN) Authentication: If the Local Security Gateway has a dynamic IP, select this
type. When the Remote Security Gateway requests to create a tunnel with the Router, the Router will work as a
responder. If you select this type, just enter the Domain Name for Authentication; the Domain Name must be
same as the Remote Security Gateway of the remote VPN device. The same Domain Name can be used only for
one tunnel connection, and users can't use the same Domain Name to create a new tunnel connection.
Dynamic IP + E-mail Addr.(USER FQDN) Authentication: If the Local Security Gateway has a dynamic IP, select
this type. When the Remote Security Gateway requests to create a tunnel with the Router, the RV042 will work as
a responder. If you select this type, just enter the E-mail address for Authentication.
Local Security Group Type
Select the local LAN user(s) behind the router that can use this VPN tunnel. Local Security Group Type may be a
single IP address, a Subnet or an IP range. The Local Secure Group must match the Remote VPN Client's Remote
Secure Group.
IP Address: If you select IP Address, only the computer with the specific IP Address that you enter will be able to
access the tunnel. The default IP is 192.168.1.0.
Subnet: If you select Subnet (which is the default), this will allow all computers on the local subnet to access the
tunnel. Enter the IP Address and the Subnet Mask. The default IP is 192.168.1.0, and default Subnet Mask is
255.255.255.192.
IP Range: If you select IP Range, it will be a combination of Subnet and IP Address. You can specify a range of IP
Addresses within the Subnet which will have access to the tunnel. The default IP Range is 192.168.1.0~254.
Chapter 6: Set Up and Configure the Router 48
VPN Tab - Client to Gateway