Resetting Welding Parameters To The Factory Settings - EWM M1.83-B-1 Operating Instructions Manual

Rectifying faults

Resetting welding parameters to the factory settings

7.5 Resetting welding parameters to the factory settings
All customised welding parameters that are stored will be replaced by the factory settings.
Display
42
RESET
0
l
Setting/selection
Calibration
The machine will be calibrated for approx 2 seconds each time it is switched on.
Initialising
Keep the push-button pressed until
+ +
Figure 7-1
is shown on the display.
099-M183xB-EW501
18.7.2022