Graco TURN2ME Instruction Manual page 129

s
How to Lock Your Lap and Shoulder Vehicle Seat Belt
Sliding Latch Plate and Switchable Retractor
A latchplate that slides freely on the belt webbing and
cannot, by itself, hold the belt snug around a car seat.
When installing the car seat, route the vehicle seat belt
through the proper belt path and buckle it in. Slowly pull
the shoulder belt all the way out to switch it to locking
mode. Then, as you pull the vehicle seat belt tight, feed all
the slack back into the retractor.
Grab the sides of the seat at the belt path and slide the seat
side-to-side and front-to-back. The seat should not move
more than 1" (2.5 cm).
Note: When using the lock-off, you are not required to
switch the retractor as an installation step. The lock-off locks
the seat belt. However, it is recommended to switch the
retractor after the installation is complete to avoid a possible
strangulation risk.
• When using the SnugLock
belt into the proper belt path under the lock-off and buckle.
Push down firmly on the center of the seat while pulling
on the shoulder belt to remove the slack. Do not pull on
the strap with excessive force. Close the SnugLock
off. Test for tightness. Slowly pull the shoulder belt all the
way out to switch it to locking mode.
lock-off, route the vehicle seat
®
129
lock-
®