Rhino-Rack Pioneer 43235 Instructions

Important: Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the bracket is installed in the correct locations.
Check the contents of kit before commencing fitment and report any discrepancies.
Place these instructions in the vehicle's glove box after installation is complete.
Item Component Name
1 Recovery Bracket
2
M10 x 100mm Hex Bolt
3 M10 Spring Washer
4 M10 Hex Nut
5
M6 x 16 Socket Head Screw
6 M6 Spring Washer
7 M6 x 12.5mm Flat Washer
8 M6 Channel Nut
9 M10 Turn Knob
10 Torque Security Key
11 Instructions
Important Note:
Sideways mount position is not recommended for Pioneer Tray and Pioneer Tradie if it has four or less planks as it may cause inteference.
Recommendations:
Clean product prior to fitting the Pioneer Recovery Tracks Bracket.
The recommended maximum number of recovery tracks fitted on a set of bracket is four.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia.
(Ph) (02) 9638 4744
(Fax) (02) 9638 4822
These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
1
Assemble the pin hardware as shown. Tighten in
place. Torque 10-13Nm.
4
3
1
2
Pioneer Recovery Track Flat Bracket (43235)
Qty. Part No.
2 CA1823
4 B259
4 W061
4 N075
4 B031
4 W004
4 W003
4 N002
4 M874
TOR-
1
KEY-SXB
1 R1203
Document No: R1203
Prepared By: Peter Luu
Authorised By: Chris Murty
Parts List
10
Tools required: 16mm spanner.
Instructions
2
Assemble the M6 hardware as shown. Finger tighten
only at this stage.
8
Any hole can be used to achieve minor adjustments in bracket
positions.
9
4
3
1
2
Issue No: 03
Issue Date: 29/11/17
5
5
7
5
5
7
8
Page 1 of 2