Rhino-Rack Pioneer High Lift 43219 Manual

Important: Please read these instructions carefully prior to installation.
Please refer to your fi tting instruction to ensure that the Roof Rack System is installed in the
correct location.
Check the contents of kit before commencing fi tment and report any discrepancies.
Recommendations: NEVER mount brackets on two
adjacent pioneer planks. Always have mounted with
minimum two plank spacing to evenly support the
load.
1.
3.
6.
1
Before installing the brackets, decide on the orientation
that would best suit your needs. The bracket can be
installed at the side or rear of the platform. Note that
for the sides of the platform, bring the brackets in to
the fi rst plank as opposed to the side extrusion.
For a rear installation
the side extrusion can
be used on one side
as shown.
43219 Pioneer High Lift Jack Bracket
Item
2.
Tools Required:10mm Socket Wrench/ Spanner.
Note: 43219 High Lift Jack Brackets are intended for use with Pioneer
4.
5.
range only. Always use caution and seek help with lifting heavy high lift
7.
jacks above roof of vehicle. Check M10 turn knobs are tight before driving.
Locking cables 43205, 43206 are recommended.
For a side installation,
bring the brackets in
to the fi rst plank.
Component Name
1 M10 Turn Knob
2 High Lift Rear Bracket
3 High Lift Front Bracket
4 M6 x 16mm Hex Bolt
5 M6 Spring Washer
6 M6 x 12mm Flat Washer
7 M6 Plate Nut
8 Instructions
2
Install the mounting hardware to the bracket. Finger
tighten at this stage (rear and front bracket installed in
the same method).
Side setup
Rear setup
(slots in
bracket used).
CONTROLLED
Qty Part No.
2 M874
1 43219-01
1 43219-02
4 B168
4 W004
4 W003
2 C593
1 R1225
Page 1 of 2