Rhino-Rack 43173 Quick Start Manual

Place these instructions in the vehicle's glove box after installation is complete.
Important: Please read these instructions carefully prior to installation.
Please refer to your fi tting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fi tment and report any discrepancies.
Item Component Name (Dual Bracket Kit)
1 RH LED Light Bracket
2 LH LED Light Bracket
3 M8 x 20 Button Cap Screw
4 M8 Spring Washer
5 M8 x 17 Flat Washer
6 M8 Channel Nut
7 Security Allen Key 5mm
8 M8 Tooth Grip Washer
9 M6 x 20 Socket Head Screw
10 M6 Spring Washer
11 M6 x 16 x 1.6 Flat Washer
12 M6 Shake Proof Washer
13

Fitting Instructions

1
Measure the length of your Light Bar to determine
what tray planks will be used in the install of the
brackets. Refer to pg 2 for all possible fi t sizes.
Front View:
3
Determine whether your Light Bar requires M6 or
M8 hardware.
For an M8 setup use items : 3,4,5 and 8 as shown.
For an M6 setup use items: 9,10,11 and 12 as
shown.
8.
12.
43173 - Pioneer Platform/ Tradie LED Light Bracket
Does not fi t Pioneer Welded Tray.
Qty
1
1
4
4
4
2
1
2
2
2
2
2
1
(x)
80mm
5.
4.
3.
11.
10.
9.
Part No.
CA1436
1
CA1435
B155
W019
W020
N003
H021
W033
B054
W004
7
W031
W056
R718
2
Attach the Brackets onto the Platform by fi rst
sliding an M8 Channel nut into the 'C' channel of the
Platform. Place the bracket over this and fi x in place
with an M8 Button Head Screw, M8 Sping and Flat
Washer.
4
Fix the Light Bar to the Brackets using the hard-
ware supplied within the Light Bar Kit purchased.
Note: Light Brackets can be fi tted to every side
of the Pioneer Platform or Tradie Tray. On the
Pioneer Tray light brackets can only fi t the rear
and sides.
Top View:
CONTROLLED
2
3
4
8 5
6
9
10
11
12
Page 1 of 3