HUSTLER FasTrak SmoothTrak Steering User Manual page 145

Verify safety start interlock system
Visually inspect unit for loose hardware and/or damaged parts
Visually inspect tires
Check oil level, engine (1)
Clean air intake screen (7)
Check fuel level
Blades - sharpen & securely fastened
Discharge chute - securely in place & in lowest position
Clean engine and transaxle compartment (10)
Change transaxle oil and filter (6)
Replace engine air cleaner element (3) (9)
Grease front wheel bearings
Change engine oil and filter (1)
Clean cylinder and head fins (9)
Check battery connections (10)
Check tire pressure with a gauge
Check hydraulic oil level
Clean engine exterior (9)
Tighten lug nuts on wheels (2)
Clean & regap spark plugs (9)
Check transaxle and deck belt tension and condition (4) (10)
Check fuel system (5) (10)
Check hydraulic lines
Check fuel valve (5)
Check fuel tank grommet (5)
Change fuel filter (5)
Replace spark plugs (9)
Check ROPS mounting hardware (8)
Replace fuel evaporation system filter (7) (10)
NOTES:
1. Initial oil and filter change is after 50 hours of operation. Thereafter, change oil and filter after every 100 hours operation. Change more often
under dusty or dirty conditions and during hot weather periods. Hustler
2. Torque initially and after first 2 hours of operation.
3. Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter
element. Replace with a new one.
4. Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Otherwise, replace every 200 hours or 2 years which-
ever comes first.
5. Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon can-
ister, and grommets. Repair as needed.
6. Initial system oil and filter change must be after the first 75 hours of use or 1 year whichever comes first. Thereafter, replace filter and oil in each
transaxle every 2 years or 200 hours, whichever comes first. Hustler
7. More often under dusty or dirty conditions and during hot weather.
8. Inspect ROPS after the first 20 hours of operation and then after every 300 hours of operation or yearly whichever comes first.
9. Refer to engine owner's manual for engine service information.
10. Any maintenance operation that requires the removal of safety covers must be performed by a trained service technician.
* After completing maintenance cycle (300 hours), repeat cycle.
608622CE
Maintenance Schedule
Figure 4-7, Figure 4-13, Figure 4-9 & Figure 4-10
SERVICE AT
INTERVALS INDICATED
WEEKLY MONTHLY
OR 50 OR 100
HOURS HOURS
Prior to each use
Prior to each use
Prior to each use
Prior to each use or every 4 hours
Prior to each use or every 4 hours
Prior to each use
Prior to each use
Prior to each use
Daily
Every 200 hours or 2 years
As needed
X
X
X
X
X
X
X
X
® Engine Oil and filters are recommended.
®
Full Synthetic 20W50 Hydrostatic Transmission Oil is recommended.
4-9
* ANNUALLY
OR 300
HOURS
X
X
X
X
X
X
X
X
X
X
X
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV
REV A