Download Print this page

Toro Grandstand 78525 Installation Instructions Manual page 9

48in, 52in, or 60in blower and drive kit

Advertisement

7.
Align the new pulley assembly so that the
openings fit over the nuts
Figure 10
1. Pulley assembly
8.
Turn the pulley to lock it into position
Note:
If the pulley does not turn, loosen the
nuts more to raise the nuts and allow the pulley
to lock into position.
Figure 11
1. Pulley assembly
9.
After the new pulley assembly is in position,
tighten the nuts to secure new pulley assembly.
Torque the 3 nuts to 28 to 34 N∙m (21 to 25 ft-lb).
10.
Using the 3 nuts that you removed previously, 1
carriage bolt (3/8 x 1-1/4 inches), and 2 carriage
bolts (3/8 x 1 inch), install the idler assembly to
the mower deck
(Figure
11.
Install the deck belt.
(Figure
10).
g302411
2. Nuts
(Figure
11).
g302414
5).
5
Installing the Blower
Assembly, Belt, and Belt
Cover
Parts needed for this procedure:
1
Blower assembly
1
Belt
1
Belt cover
1
Knob
1
Hose
1
Hose clamp
Procedure
Refer to the bagger Operator's Manual for the correct
procedure to install the blower assembly, belt, and
belt covers.
9

Advertisement

loading

This manual is also suitable for:

Grandstand 78526Grandstand 78527