Advertisement
3
Installing the Pulley and
Idler Assemblies
For Machines with a Cast-Iron
Spindle
Parts needed for this procedure:
1
Blower mount
1
Bolt (1/2 x 1-1/2 inches)
1
Lock washer
1
Nut (1/2 inch)
1
Bolt (3/8 x 1-1/4 inches)
1
Nut (3/8 inch)
1
Carriage bolt (3/8 x 1-1/4 inches)
1
Carriage bolt (3/8 x 1 inch)
1
Idler assembly
1
Pulley assembly
Procedure
1.
Install the blower mount to the deck using 1 bolt
(1/2 x 1-1/2 inches), 1 lock washer, 1 nut (1/2
inch), 1 bolt (3/8 x 1-1/4 inches), and 1 nut (3/8
inch) as shown in
Note:
You may need to loosen the 3 baffle bolts
when you install the blower mount to align the
assembly with the deck. Tighten the bolts after
installing the mount.
Figure
3.
1. Nut (3/8 inch)
2. Blower mount
3. Bolt (3/8 x 1-1/4 inches)
4. Baffle bolt (3)
5
Figure 3
5. Bolt (1/2 x 1-1/2 inches)
6. Lock washer
7. Nut (1/2 inch)
g194670
Advertisement
