Shooting A Snapshot While Shooting A Movie - Casio EX-ZS10RD User Manual

Table of Contents

NOTE

• Spending a long time using movie recording will cause the camera to become

slightly warm to the touch. This is normal and does not indicate malfunction.

• The camera also records audio. Note the following points when

shooting a movie.

– Take care that the microphone is not blocked by your fingers,

etc.

– Good recording results are not possible when the camera is

too far away from what you are trying to record.

– Operating camera buttons while shooting can cause button

noise to be picked up in the audio.

• Shooting a very bright subject can cause a vertical band or a pink cast on the

monitor screen image. This does not indicate malfunction.

• When using the camera's built-in memory or certain types of memory cards, it can

take too much time to record data, which can result in breaks in the image and/or

audio. This condition is indicated by » and Y flashing on the monitor screen. To

avoid loss of movie frames, use of a memory card with a maximum transfer speed

of at least 10MB per second is recommended (page 125).

• Only digital zoom can be used for zooming during movie recording. Since optical

zoom is not possible while recording a movie, zoom as required before pressing

[0] (Movie) to start recording.

• The effects of camera movement in an image become more pronounced when you

shoot close up or with a large zoom factor. Because of this, use of a tripod is

recommended under these conditions.

• Focus is fixed while movie recording is in progress.