Advertisement
4
Installing the Control Panel
and Sunshade
Parts needed for this procedure:
1
Sunshade
1
Control panel
4
Hole plug
12
Plastic rivet
4
Clip
4
Sealing washer
4
Hex-head-flange bolt (1/4 x 1 inch)
1
Serial plate
2
Pop rivet
Procedure
1.
Install the 4 hole plugs to the control panel
(Figure
9).
Note:
If you are installing other accessories in
the control panel holes, do not install the hole
plugs.
1. Serial plate
2. Pop rivet
3. Plastic rivet
2.
Use 2 pop rivets to secure the serial plate to the
control panel
(Figure
Note:
Install the serial plate so that it can be
read by the operator.
3.
Align the mounting holes on the control panel
with the holes in the front roof mount
Figure 9
4. Hole plug
5. Control panel
9).
(Figure
4.
Secure the front panel onto the front roof mount
by inserting 12 plastic rivets into their respective
holes and pushing the plunger on each plastic
rivet until it is secure
5.
Install the sunshade onto the frame with 4
hex-head flange bolts (1/4 x 1 inch), 4 sealing
washers, and 4 clips
1. Sunshade
2. Hex-head-flange bolt (1/4
x 1 inch)
5
Completing the Installation
No Parts Required
Procedure
g201626
1.
Install any attachments that you previously
removed, such as lights, onto the left and right
panels.
2.
Ensure that all fasteners are tightened.
9).
8
(Figure
9).
(Figure
10).
Figure 10
3. Sealing washer
4. Clip
g201637
Advertisement
