Kruger KCE 300 M Series General Instructions

Installation Instruction
1. Frame Installation
Use strengthened frame to support the whole weight of the
main body.
Woodframe use : 30 x 30 mm
2. Connecting Pipe
Put the body into the fixing frame, make a mark on it as per
the hole position shown in the arrow and remove the body
(fig.1).
Tighten the wood screw at the mark (fig.2).
3. Main Body Installation
Insert the main body aligned with connecting pipe.
Fix it temporally by wind screw.
body tightly and fixed it by
Connect the pipe with main
additional screws #10x25 (5 pcs).
4. Connecting & Exhaust pipe
Seal up the connecting place by adhesive tap or joint
mixture.
Tilt down the exhaust pipe to outdoor about 1° or 2°.
5. Electrical Distribution
Choose the corresponding wiring diagram per your
purchased model.
A – normal model
B – remote control model
6. Ceiling Installation
Keep a space of 1 to 2mm between ceiling and outer rim of
main body. Thickness of ceiling shall be less than 25mm.
7. Test run and Installation of grille
Switch power on and check operation.
Remote control model – put the plug of the remote control .
power cord in the socket on IC board in the grille (fig.4).
Maintenance
1. Ensure the fan is disconnected from the main power supply before any
service.
2. Do not use petrol oil or any other plastic-erosive oil for cleaning.
3. Remove the grille.
4. Clean the grille using lukewarm water neutral detergent and rinse
5. Wipe the main body with cloth and neutral detergent.
6. Fit the grille back when it is dry.
Caution
1. A double interruption jack must be installed at the wire inlet in order to isolate
power supply in case of emergency.
2. Do not install the fan at a place where water spray or excess steam exists.
3. Do not install the fan at a place with high humidity.
4. Check the voltage and frequency on the name plate against local power supply
5. Installation height should be at least 2.5m above floor.
maintenance and
with clean water.
the fan and
before usage.
General Instructions
KCE 300-600 M Series
IGB027.E1/2002