Download
Share
Print this page
  1. Manuals
  2. Brands
  3. NanaWall Manuals
  4. Folding Machines
  5. WD65
  6. Owner's manual

NanaWall WD65 Owner's Manual

Wood framed top-hung folding system
Hide thumbs

Advertisement

Quick Links

Download this manual
Owner' s Manual
NanaWall WD65
Wood Framed Top-Hung Folding System
This Owner's Manual contains instructions on the installation, operation, maintenance and warranty of
the NanaWall WD65 Wood Framed Top-Hung Folding System. This manual is to be used by the installer
for installation and is to be kept by the Owner for reference. Replacement parts can be ordered directly
through NanaWall Systems.
Nana Wall Systems, Inc.
100 Meadowcreek Drive #250
Corte Madera, CA 94925
800 873 5673
info@nanawall.com
nanawall.com
415 383 3148
Fax 415 383 0312
©2022 Nana Wall Systems, Inc.

Advertisement

loading

Related Manuals for NanaWall WD65

Summary of Contents for NanaWall WD65

  • Page 1 This Owner’s Manual contains instructions on the installation, operation, maintenance and warranty of the NanaWall WD65 Wood Framed Top-Hung Folding System. This manual is to be used by the installer for installation and is to be kept by the Owner for reference. Replacement parts can be ordered directly through NanaWall Systems.
  • Page 2 Panels are pre-assembled with or without glass, ready to be attached to the installed frame. In most The installation of the WD65 System requires a working cases, all hinges, weather stripping, multiple locking, and knowledge and experience in the use of tools, equipment,...
  • Page 3 NANAWALL WD65 OWNER’S MANUAL The structural integrity of the header is critical for • Lever handles, other handles or other entry hardware proper operation. Vertical deflection of the header as ordered. These may be pre-attached to the panels. under full live and dead loads should be the lesser of •...
  • Page 4 NANAWALL WD65 OWNER’S MANUAL 6. For better performance and protection, any exterior folding system should be installed under an overhang or with other similar protection. For better performance it is recommended that all dead loads such as upper levels, roof, etc. be constructed before a unit is installed.
  • Page 5 RECOMMENDATIONS and the directions of the products be followed explicitly. NanaWall wood framed systems are shipped with a factory In general, the surface must be prepared by cleaning off applied layer of a water born translucent coat of sand dust and any debris.

  • Page 6: Unit Installation

    It might be easier to drill the holes as descript in Step A6 please check whether such holes are required and drill before assembling the frame. them if necessary. Please be careful to avoid scratching or damaging the components. DIAGRAM 1: WD65 EXAMPLE OF A 3 PANEL UNIT INWARDS OPENING. Panel Holder...
  • Page 7 NANAWALL WD65 OWNER’S MANUAL Use appropriate screws or other equivalent anchorage Step A2 devices depending on the adjacent substrate material and Assemble all frame parts as shown in Diagram 1. Do not construction. Make sure they are corrosion resistant. apply sealant to the corner joints yet.
  • Page 8 NANAWALL WD65 OWNER’S MANUAL DIAGRAM 3: SUGGESTED FRAME FASTENING POINTS A = About 4" from the interior edge. B = Distance about 16", except at the stacking area on one or both sides where spacing should be about 4". Plus extra screws at meeting point of panels.
  • Page 9 NANAWALL WD65 OWNER’S MANUAL DIAGRAM 2: WD65 SUGGESTED TYPICAL INSTALLATION Drawings not to scale. Suggested Typical Installation drawings shown are very general and may not be Details shown are subject to suitable for any particular installation. Product placement, fasteners, flashing, change without notice.
  • Page 10 NANAWALL WD65 OWNER’S MANUAL B. PANELS AND FOLDING HARDWARE Step B5 INSTALLATION Attach additional panels in the same manner. IMPORTANT: Look for glass stops to determine the C. FINAL STEPS interior side of a panel. Step C1 Attach handles and other hardware that have not been pre-attached.
  • Page 11 NANAWALL WD65 OWNER’S MANUAL Step C5 Step C10 Check all vertical joints: Apply a thick bead of exterior grade sealant with a backer rod if needed on the joint between the sill and sub floor Make sure that the side jambs are still vertically straight.
  • Page 12 It is highly recommended that if not used, the NanaWall folding unit be kept closed as much as possible, in order to provide best security and weather resistance. When closed, please engage all locking mechanisms fully.
  • Page 13 NANAWALL WD65 OWNER’S MANUAL OPERATING THE SL-MULTIPOINT LOCKING ON THE PRIMARY SWING PANEL LOCKING UNLOCKING Normal position Engaging Locking Unlocking Disengaging locking points (Note that this is not one motion operation. Key or thumbturn must be unlocked first.) Be sure to check that the door is locked.
  • Page 14 A unit with worn or damaged on the exposure of the NanaWall unit. Periodically components will compromise the performance level repaint or restain the wood as needed. Exposure...
  • Page 15 NANAWALL WD65 OWNER’S MANUAL See Finishing Recommendations in the Owner’s After washing, the surface should be rinsed Manual of the wood systems. thoroughly with clean water and allowed to dry. 9. All hardware, hinges and handles should be b. For cleaning, do not use abrasive household...
  • Page 16 Proper glass installation is critical, as, with the NanaWall each succeeding panel. This is necessary for the stability folding system, glass is a structural part of the panel.
  • Page 17 APPENDIX A NANAWALL WD65 OWNER’S MANUAL a proper fit, shift the glass weight by lifting the panel 3. Measure both the vertical and horizontal dimensions up with a plastic pry bar at the lower corner below of the glass and the panel opening. Subtract the the upper setting block.
  • Page 18 APPENDIX A NANAWALL WD65 OWNER’S MANUAL 13. After installing the panels, assuming that the head jamb and sill are level, check to see if the gap between the panel and head jamb and panel and sill is even across the width of the panel. With the glass weight, the out of square panels should become almost even.
  • Page 19 May 1, 2022, to be installed in the United States (excluding territories) or Canada. NanaWall shall have no obligation to respond under this Warranty until receipt of proper notice of a claim and an opportunity to respond. Upon notice and confirmation by NanaWall of a condition covered under this Warranty, NanaWall will respond in good faith and in a timely manner as follows: TEN YEAR COVERAGE.

  • Page 20: Additional Service Information

    Screens. For a screen part (excluding the screen mesh) with a material or workmanship issue that substantially impairs the function of the screen, NanaWall will, at its option, (1) ship a replacement screen or (2) upon return by owner, repair the screen without charge.
  • Page 21 This Warranty may only be modified by a writing signed by an officer of NanaWall. Any action taken by NanaWall does not create a new warranty or extend the duration of the original product warranty. A failure by NanaWall to enforce a warranty provision shall not constitute a waiver barring subsequent enforcement.
  • Page 22 • Products or components not supplied by NanaWall; Products that have not been paid for in full; Products ordered in larger sizes or special configurations beyond NanaWall’s published specifications. Product with glass that is heavier than NanaWall specifications;...
  • Page 23 NanaWall Warranty Registration Must be filled out and returned to Nana Wall Systems, Inc., 100 Meadowcreek Drive, Corte Madera, CA 94925 within 30 days from date of purchase of the NanaWall in order for the limited warranty to become effective. ________________________...