Watching - Panasonic LZ1000G Series Operating Instructions Manual

Select the language
Select your country
Select [Home]
Select [Home] for use in a home viewing environment.
[Shop] is for shop display.
≥
≥ To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection
Tick the TV signal mode to tune, and then select
[Start Auto Tuning]
≥ If you use an RF selector, switch it to the digital TV
signal before starting the Auto Tuning. As soon as the
digital TV scan is finished, switch it to the analogue TV
signal to tune analogue channels. Even if some
channels are not tuned correctly, you can try to tune
them by [Auto Tuning] in the [Setup] menu.
Select your region (Digital TV)
Enter your postcode
Indonesia
∫ When you select the analogue TV signal,
select your area.
≥ When selecting [CATV/Other], press the OK button,
and then select the Channel Plan from Indian CATV,
South Africa, American System, American CATV or
Japan CATV.
Auto Tuning is now complete and the
TV is ready for viewing.
If tuning has failed check the RF cable, and the network
connection, and then follow the on-screen instructions.
Note
The TV goes into Standby mode when no signal is
≥
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
To retune all channels
≥
[Auto Tuning] in [Tuning Menu] ([Setup] menu)
To add the available TV signal mode later
≥
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
To initialise all settings
≥
[Shipping Condition] in [System Menu] ([Setup]
menu)
Malaysia
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
≥
(p. 21)
2
Select Digital TV or Analogue TV
If you use an RF selector, switch it whenever you
≥
switch between Digital TV and Analogue TV.
3
Select a channel
up
down
or
To select a channel position with 2 or more-digit, e.g.
≥
399
23
English