Watching - Panasonic TH-48LZ980Z Operating Instructions Manual

Select the language
Select [Home]
Select [Home] for use in a home viewing environment.
[Shop] is for shop display.
≥
≥ To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection
Tick the TV signal mode to tune, and then select
[Start Auto Tuning]
Select your region (Satellite)
Auto Tuning is now complete and the
TV is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
Note
The TV goes into Standby mode when no signal is
≥
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
To retune all channels
≥
[Auto Tuning] in [Tuning Menu] ([Setup] menu)
If no satellite channel is found, set [LNB Band
≥
Frequency] to suit your environment.
[LNB Configuration] in [Satellite TV Tuning
Menu] ([Setup] menu)
To add the available TV signal mode later
≥
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
To initialise all settings
≥
[Shipping Condition] in [System Menu] ([Setup]
menu)
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
≥ Mains power On / Off switch should be on.
(p. 21)
2
Select the mode
Selectable modes vary depending on the stored
≥
channels.
3
Select a channel
up
down
or
To select a channel position with 2 or more-digit, e.g.
≥
399
23
English