Pisla 70100030 Instruction Manual page 38

6. Getting started
6.1 Inserting the batteries in the receiver
• Place both instruments on a desk with a distance of approximately 1.5 meter. Avoid getting close to
possible interference sources (Electronic devices and radio installations).
• Remove the protective foil from the display of the receiver.
• Connect the basic station to the attached micro-usb wire,and put USB port into 5V/1A power part,like
computer,the charger of phone,etc. (This way the backlight will be light all time.)
• Or remove the battery cover and insert two new batteries 1,5V AAA,polarity as illustrated,Close the
battery compartment again. (This way the backlight will be not light all the time, it need press button to
turn on the backlight,and the backlight will light few seconds then auto turn off.)
• The device will alert you with a beep and all LCD segments will be displayed for a short moment.
• The default:
TIME:2019-1-1, 0:00;
Hour system: 24hr;
• The pressure is blinking,press
if no button pressed,then after 20s it will be auto quit the setting and go to RF search.
6.2 Inserting the batteries in the outdoor transmitter
• Open the screwed battery compartment of the outdoor transmitter.
• The slide switch for channel selection is at position 1 (default).
• Insert two new batteries 1,5 V AAA, polarity as illustrated.
• Close the battery compartment again.
AL1: 6:00, OFF ;
Temperature unit: °C;
or to adjust the value,press "SET" to confirm and quit;
AL2: 0:00, OFF