McIntosh MDA200 Owner's Manual page 8

Navigating the Setup Menu
Entering Setup Menu:
To enter the Setup Menu, push and hold the
INPUT knob. Once the display shows the unit
model, the firmware version, and the serial
number, release the knob and you are in the
setup menu. See next section for the setup menu
overview.
Note: "Enter Code" will appear if the INPUT knob is held
too long. This is for support purposes only. Press the
knob again to exit.
Selecting/Adjusting Menu Settings:
You can navigate through and select the different
options in the menus by rotating the INPUT knob.
To adjust a selected setting, use the ADJUST
knob. If a category in a menu has a submenu
available, the display will show "Hold Input",
allowing you to hold down the INPUT knob to
see additional options.
Exiting/Navigating Back:
A brief deliberate press (not hold) and release of
the INPUT knob will exit the current menu. Make
additional presses until the display shows the
main operating screen to continue normal use of
the unit.
8
Setup Menu Settings and Options
Setting Options
S/N AKTxxxx Displays the serial number
of the MDA200
MDA200 V_ . _ _
DA2 V_ . _ _
Setup: Level Fixed / Adjustable
Adjust
INPUTS On / Rename
HDMI CEC VOL Control Command
On / Off
(Consumer Elec-
tronic Control)
HDMI CEC Power On or Off
PWR
Lip Synchronize Auto / Manual
Mode (Audio
Only)
Digital Gain (for 0-15dB
HDMI, Optical
1&2)
DATA PORT All Data / Individual Input
RS232 115200 Baud Default
IR Codes Normal / Alternate
Front IR Enabled / Disabled
Power IR Enabled / Disabled
Input IR Enabled / Disabled
Trim IR Enabled / Disabled
Auto-Off Enabled / Disabled
Factory Reset Default Settings
Setup Menu Settings
The following is a list of the available settings
options. A down arrow ↓ represents being taken to
a submenu after holding the INPUT knob while
the display says "Hold Input". The selectable
options will be listed in brackets [ ] and separated
by commas, with a brief description underneath of
what each option does when selected.
Serial Number:
The MDA200's unique serial number can be
viewed by entering the setup menu and rotating
the INPUT knob until you see "S/N:". The num-
bers and letters to the right are the unit's serial
number. This number can also be found on the
rear of the unit.
Firmware Version:
Firmware is internal software that controls the
MDA200's functionality. Firmware upgrades
when available can be installed by qualified
technicians.
The version of the main firmware of the MDA200
can be viewed by entering the setup menu. The
first setting is called MDA200. The number to the
right is the version number. For example, if the
VFD displays "MDA200 V1.01", then the main
firmware is version 1.01.
There is also firmware for controlling the digital
audio hardware. To see the digital audio firmware
version, enter the setup menu and rotate the IN-
PUT knob until you see "DA2 FIRMWARE". The
number following the V to the right is the digital
audio firmware version.