Acura TSX 2008 Service Bulletin

2008 TSX – ALL
Applies To:
2008 TSX: TQI and New Model Information
This service bulletin gives you the information needed
for the TQI of the 2008 TSX. It also describes new
service information for the TSX.
NOTE: For TQI information on the DVD navigation
system with voice recognition, refer to Service Bulletin
05-041, 2006–08 TSX: TQI of the DVD Navigation
System With Voice Recognition.
This bulletin includes these TQI procedures:

• Install the Fuse

• Do the Idle Learn Procedure

• Set the Radio and the Clock (Models Without
Navigation System)
• Install the Floor Mats
• Remove the Interior Protective Coverings
• Peel Off the Switch and Button Film
• Install the Shift Lock Release Cover (A/T Models)
• Initialize the Driver's Window Auto-Up/Down
Feature
• Install the Front License Plate Holder
• Set the Tire Pressures
• Initialize the Tire Pressure Monitoring System
• Check/Refresh the XM
Demo Service (All Except Alaskan and Hawaiian
Models)
This bulletin provides this new model information:
• TPMS Indicator
WARRANTY CLAIM INFORMATION
None. The information in this service bulletin is
considered part of the TQI.
© 2007 American Honda Motor Co., Inc. – All Rights Reserved
CLIENT INFORMATION:
The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by "do-it-yourselfers," and you should not assume this
bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an authorized
Acura automobile dealer.
Service Bulletin
®
Satellite Radio Dealer
TQI PROCEDURES
NOTE: Make sure you record the TQI on the
appropriate pages of the vehicle's maintenance journal.
The TQI procedure is not finished until this bulletin and
the maintenance journal checklist are both completed.
Install the Fuse
To prevent battery drain during vehicle shipment, the
No. 15 fuse (40 A, Backup) is removed from the under-
hood fuse/relay box and stored in the glove box. Install
this fuse.
Do the Idle Learn Procedure
NOTE: Idle speed adjustment is done by the ECM/
PCM; there is no adjustment screw.
To avoid an erratic idle, do the idle learn procedure
after you install the No. 15 fuse.
1. Make sure all electrical items (A/C, radio, rear
window defogger, lights, etc.) are off.
2. Start the engine, and let it reach operating
temperature (the cooling fans cycle twice).
3. Let the engine idle for 10 minutes with the throttle
closed.
The idle learn procedure must also be done after
updating or replacing the ECM/PCM. It does not need
to be done after you clear DTCs.
BTB 37048 (0706)
07-030
June 27, 2007
40 A BACKUP FUSE
1 of 5