Page 1
Improper and unsafe use of this tool will result in death or serious injury. It is very important that the intended operator of this tool reads and understands this manual before operating this tool. Keep this manual available for others before they use the tool. 0508 782 753 | sales@delfast.com Freephone Email @DelfastNZ #Delfast delfast.com...
Correct air plant and correct installation of the tool Your tool - safety aspects Operation Instructions Loading and Unloading the Fastener Depth of Drive Adjustment Jam Clearing Technical Characteristics Maintenance Instructions General Maintenance Cleaning Storage Troubleshooting Guide Notes & Service History Freephone. 0508 782 753 Email. sales@delfast.com...
Thank you for buying this Delfast Fastenings tool. It has been designed, built and tested according to all current norms and laws. These include European Directive 89/392 and subsequent amendments, EN 292, EN 792-13 and ANSI ISANTA SNT-101-1993. BEFORE STARTING TO USE THIS TOOL OR BEFORE CARRYING...
Any attempt to modify the tool in any way, without the written approval from Delfast, will void the warranty. Do not remove or render inoperable any of the operating controls. Never tamper with, block or remove the work contacting element.
Always assume that the tool is loaded. Always use the tool in safe way. Check that the tool is in good condition before starting to use it. In case of doubt contact Delfast. Use only genuine Delfast 4.00mm staples.
Unscrew hex bolt connecting the handle to the magazine with a 5mm allen key drive (Image F) • • Seperate magazine from gun • Remove staple using needle nose pliers (Image G). Assemble magazine to gun back together before further use (Image D) (Image E) (Image F) (Image G) delfast.com...
Use only genuine Delfast replacement parts. These are produced to the same standards as the original parts of the tool. The use of parts which are not made by Delfast could reduce the life of the tool to become unsafe.
Remove all fasteners from the tool before commencing work. • Test fire the tool two or three times without fasteners before loading. • If the repair cannot be carried out by following the guidelines below, please contact Delfast. Fault Probable cause Remedy 1.
Notes & Service History Freephone. 0508 782 753 Email. sales@delfast.com...
Page 11
PNEUMATIC HOW TO WATCH OUR VIDEOS ONLINE AT: delfast.com/videos delfast.com...
Page 12
Improper and unsafe use of this tool will result in death or serious injury. It is very important that the intended operator of this tool reads and understands this manual before operating this tool. Keep this manual available for others before they use the tool. 0508 782 753 | sales@delfast.com Freephone Email @DelfastNZ #Delfast delfast.com...