Advertisement
1
Connecting to your amplifier
A
Caution
• Be careful not to short the two pins (1+ and 1–) of the
free speaker terminal. Doing so could damage the
speaker and your amplifier.
• Switch off the amplifier before connecting any
speakers.
There are two connection terminals on the rear side of
the speaker. To connect the speaker to your amplifier you
will need a suitable speaker cord terminated in a Neutrik
B
®
Speakon
speaker connector [NL4MP]. Only the 1+ and
1– pins should be connected. These connect to the
positive (+) and negative (–) speaker terminals
respectively on the amplifier.
Neutrik [NL4FX] and [NL4FC] Speakon speaker cord can
be used for the connection. Please refer to Neutrik for
more information.
1
Use a suitable speaker cord (not supplied) to
connect the speaker terminal on your amplifier to
one of the input terminals on the rear of the
speaker.
The speaker's terminals are exactly the same; use
C
whichever is convenient.
• See the manual that came with your amplifier for
more details.
a
Plug the speaker cord connector into the
speaker's input terminal. Check the alignment for
the connector with the jack before plugging in.
D
b
After inserting the connector fully, turn
clockwise to lock it in place.
E
• After connecting, gently pull the connector to make
sure that it is securely connected. Improper
connection can be a cause of noise or other
problems.
F
8
1
2
Squeeze the lever on the speaker connector with your
thumb, then twist the whole connector counter-
clockwise and pull out.
On the rear of the speaker are two terminals; you can use
these to connect another speaker of the same type to this
speaker.
• The number of speakers you may connect will vary
• The diagram below shows the wiring of two
Amplifier
Input
Terminal 1
S-FL1
2
3
Disconnecting
2
1
Connecting another speaker
S-FL1
Amplifier
according to the impedance rating of the amplifier.
See the manual that came with your amplifier for
more details.
connected speakers.
S-FL1
+
1+
-
1-
1+
8 Ω
1-
SCHEMATIC DIAGRAM
White
1+
1+
1–
1–
2+
2+
2–
2–
Input
Black
Terminal 2
3
4
S-FL1
S-FL1
1+
1-
1+
8 Ω
1-
EXCITER
EXCITER
EXCITER
EXCITER
4
Advertisement
